On 05/05/23 12:05, Clark Wang wrote:
When all bits of IER are set to 0, we still can observe the lpspi irq events
when using DMA mode to transfer data.
So disable irq to avoid the too much irq events.
Signed-off-by: Clark Wang <xiaoning.wang@xxxxxxx>
---
drivers/spi/spi-fsl-lpspi.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/spi/spi-fsl-lpspi.c b/drivers/spi/spi-fsl-lpspi.c
index f2341ab99556..4b70038ceb6b 100644
--- a/drivers/spi/spi-fsl-lpspi.c
+++ b/drivers/spi/spi-fsl-lpspi.c
@@ -910,9 +910,14 @@ static int fsl_lpspi_probe(struct platform_device *pdev)
ret = fsl_lpspi_dma_init(&pdev->dev, fsl_lpspi, controller);
if (ret == -EPROBE_DEFER)
goto out_pm_get;
-
Any reason to delete this line?
if (ret < 0)
dev_err(&pdev->dev, "dma setup error %d, use pio\n", ret);
+ else
+ /*
+ * disable LPSPI module IRQ when enable DMA mode successfully,
+ * to prevent the unexpected LPSPI module IRQ events.
+ */
+ disable_irq(irq);
Just wondering, have you actually seen any unexpected LPSPI module IRQ
events? If this was causing issues earlier then maybe add a fixes tag?
ret = devm_spi_register_controller(&pdev->dev, controller);
if (ret < 0) {
--
Thanks and Regards,
Dhruva Gole
