[PATCH SPI for-next] spi: microchip: pci1xxxx: Fix minor bugs in spi-pci1xxxx driver

[Tharun Kumar P <tharunkumar.pasumarthi@xxxxxxxxxxxxx>]

Following bugs are fixed in this patch:
1. pci1xxxx_spi_resume API masks SPI interrupt bit which prohibits
firing of interrupt to the host at the end of the transaction after
suspend-resume. This patch unmasks this bit at resume.
2. In pci1xxxx_spi_transfer_one API, length of SPI transaction gets
cleared by unmasking length field. Set length of transaction after
unmasking length field.
3. Remove support for disabling chip select as hardware does not support
the same.

Fixes: 1cc0cbea7167 ("spi: microchip: pci1xxxx: Add driver for SPI controller of PCI1XXXX PCIe switch")
Signed-off-by: Tharun Kumar P <tharunkumar.pasumarthi@xxxxxxxxxxxxx>
---
 drivers/spi/spi-pci1xxxx.c | 12 ++++--------
 1 file changed, 4 insertions(+), 8 deletions(-)

diff --git a/drivers/spi/spi-pci1xxxx.c b/drivers/spi/spi-pci1xxxx.c
index 1c5731641a04..9a044012aca7 100644
--- a/drivers/spi/spi-pci1xxxx.c
+++ b/drivers/spi/spi-pci1xxxx.c
@@ -58,7 +58,7 @@
 #define VENDOR_ID_MCHP 0x1055
 
 #define SPI_SUSPEND_CONFIG 0x101
-#define SPI_RESUME_CONFIG 0x303
+#define SPI_RESUME_CONFIG 0x203
 
 struct pci1xxxx_spi_internal {
 	u8 hw_inst;
@@ -114,16 +114,11 @@ static void pci1xxxx_spi_set_cs(struct spi_device *spi, bool enable)
 
 	/* Set the DEV_SEL bits of the SPI_MST_CTL_REG */
 	regval = readl(par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	if (enable) {
+	if (!enable) {
 		regval &= ~SPI_MST_CTL_DEVSEL_MASK;
 		regval |= (spi_get_chipselect(spi, 0) << 25);
 		writel(regval,
 		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-	} else {
-		regval &= ~(spi_get_chipselect(spi, 0) << 25);
-		writel(regval,
-		       par->reg_base + SPI_MST_CTL_REG_OFFSET(p->hw_inst));
-
 	}
 }
 
@@ -199,8 +194,9 @@ static int pci1xxxx_spi_transfer_one(struct spi_controller *spi_ctlr,
 			else
 				regval &= ~SPI_MST_CTL_MODE_SEL;
 
-			regval |= ((clkdiv << 5) | SPI_FORCE_CE | (len << 8));
+			regval |= ((clkdiv << 5) | SPI_FORCE_CE);
 			regval &= ~SPI_MST_CTL_CMD_LEN_MASK;
+			regval |= (len << 8);
 			writel(regval, par->reg_base +
 			       SPI_MST_CTL_REG_OFFSET(p->hw_inst));
 			regval = readl(par->reg_base +
-- 
2.25.1