[PATCH] spi: cadence-quadspi: Properly pass buswidth through to underlying SPI subsystem via buswidth_override_bits instead of mode_bits.

[Nathan Barrett-Morrison <nathan.morrison@xxxxxxxxxxx>]

While trying to enable Octal SPI mode, it was observed that
SPI_RX_OCTAL/SPI_TX_OCTAL were not propagating into the spi_device
spi->mode setting.  This was causing the SPI device to always
operate in 1x mode instead of the desired 8x mode.

Signed-off-by: Nathan Barrett-Morrison <nathan.morrison@xxxxxxxxxxx>
---
 drivers/spi/spi-cadence-quadspi.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c
index 447230547945..c92a95bdaa05 100644
--- a/drivers/spi/spi-cadence-quadspi.c
+++ b/drivers/spi/spi-cadence-quadspi.c
@@ -1589,7 +1589,7 @@ static int cqspi_probe(struct platform_device *pdev)
 		dev_err(&pdev->dev, "spi_alloc_master failed\n");
 		return -ENOMEM;
 	}
-	master->mode_bits = SPI_RX_QUAD | SPI_RX_DUAL;
+	master->buswidth_override_bits = SPI_RX_QUAD | SPI_RX_DUAL;
 	master->mem_ops = &cqspi_mem_ops;
 	master->mem_caps = &cqspi_mem_caps;
 	master->dev.of_node = pdev->dev.of_node;
@@ -1686,7 +1686,7 @@ static int cqspi_probe(struct platform_device *pdev)
 			cqspi->wr_delay = 50 * DIV_ROUND_UP(NSEC_PER_SEC,
 						cqspi->master_ref_clk_hz);
 		if (ddata->hwcaps_mask & CQSPI_SUPPORTS_OCTAL)
-			master->mode_bits |= SPI_RX_OCTAL | SPI_TX_OCTAL;
+			master->buswidth_override_bits |= SPI_RX_OCTAL | SPI_TX_OCTAL;
 		if (!(ddata->quirks & CQSPI_DISABLE_DAC_MODE))
 			cqspi->use_direct_mode = true;
 		if (ddata->quirks & CQSPI_SUPPORT_EXTERNAL_DMA)
-- 
2.30.2