[PATCH] spi: bcm2835aux: Convert to use GPIO descriptors

[Linus Walleij <linus.walleij@xxxxxxxxxx>]

This one is pretty straight forward to switch over, the driver
already relies on inspecting cs_gpio just check cs_gpiod instead
and stop the special handling of requesting the GPIO and stuff
the core will take care of.

Cc: Lukas Wunner <lukas@xxxxxxxxx>
Cc: Martin Sperl <kernel@xxxxxxxxxxxxxxxx>
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
 drivers/spi/spi-bcm2835aux.c | 19 ++++---------------
 1 file changed, 4 insertions(+), 15 deletions(-)

diff --git a/drivers/spi/spi-bcm2835aux.c b/drivers/spi/spi-bcm2835aux.c
index 7d709a8c833b..af795700e31a 100644
--- a/drivers/spi/spi-bcm2835aux.c
+++ b/drivers/spi/spi-bcm2835aux.c
@@ -22,7 +22,6 @@
 #include <linux/of.h>
 #include <linux/of_address.h>
 #include <linux/of_device.h>
-#include <linux/of_gpio.h>
 #include <linux/of_irq.h>
 #include <linux/regmap.h>
 #include <linux/spi/spi.h>
@@ -450,20 +449,9 @@ static int bcm2835aux_spi_setup(struct spi_device *spi)
 	/* sanity check for native cs */
 	if (spi->mode & SPI_NO_CS)
 		return 0;
-	if (gpio_is_valid(spi->cs_gpio)) {
-		/* with gpio-cs set the GPIO to the correct level
-		 * and as output (in case the dt has the gpio not configured
-		 * as output but native cs)
-		 */
-		ret = gpio_direction_output(spi->cs_gpio,
-					    (spi->mode & SPI_CS_HIGH) ? 0 : 1);
-		if (ret)
-			dev_err(&spi->dev,
-				"could not set gpio %i as output: %i\n",
-				spi->cs_gpio, ret);
-
-		return ret;
-	}
+
+	if (spi->cs_gpiod)
+		return 0;
 
 	/* for dt-backwards compatibility: only support native on CS0
 	 * known things not supported with broken native CS:
@@ -519,6 +507,7 @@ static int bcm2835aux_spi_probe(struct platform_device *pdev)
 	master->prepare_message = bcm2835aux_spi_prepare_message;
 	master->unprepare_message = bcm2835aux_spi_unprepare_message;
 	master->dev.of_node = pdev->dev.of_node;
+	master->use_gpio_descriptors = true;
 
 	bs = spi_master_get_devdata(master);
 
-- 
2.34.1