There are few places that repeat the logic of "update if changed". Extract pxa2xx_spi_update() helper to deduplicate that. Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> --- drivers/spi/spi-pxa2xx.c | 33 ++++++++++++++------------------- 1 file changed, 14 insertions(+), 19 deletions(-) diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c index a27f51f5db65..54eaa048651f 100644 --- a/drivers/spi/spi-pxa2xx.c +++ b/drivers/spi/spi-pxa2xx.c @@ -200,6 +200,12 @@ static bool is_mmp2_ssp(const struct driver_data *drv_data) return drv_data->ssp_type == MMP2_SSP; } +static void pxa2xx_spi_update(const struct driver_data *drv_data, u32 reg, u32 mask, u32 value) +{ + if ((pxa2xx_spi_read(drv_data, reg) & mask) != value) + pxa2xx_spi_write(drv_data, reg, value & mask); +} + static u32 pxa2xx_spi_get_ssrc1_change_mask(const struct driver_data *drv_data) { switch (drv_data->ssp_type) { @@ -1081,19 +1087,12 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, dma_mapped ? "DMA" : "PIO"); if (is_lpss_ssp(drv_data)) { - if ((pxa2xx_spi_read(drv_data, SSIRF) & 0xff) - != chip->lpss_rx_threshold) - pxa2xx_spi_write(drv_data, SSIRF, - chip->lpss_rx_threshold); - if ((pxa2xx_spi_read(drv_data, SSITF) & 0xffff) - != chip->lpss_tx_threshold) - pxa2xx_spi_write(drv_data, SSITF, - chip->lpss_tx_threshold); + pxa2xx_spi_update(drv_data, SSIRF, GENMASK(7, 0), chip->lpss_rx_threshold); + pxa2xx_spi_update(drv_data, SSITF, GENMASK(15, 0), chip->lpss_tx_threshold); } - if (is_quark_x1000_ssp(drv_data) && - (pxa2xx_spi_read(drv_data, DDS_RATE) != chip->dds_rate)) - pxa2xx_spi_write(drv_data, DDS_RATE, chip->dds_rate); + if (is_quark_x1000_ssp(drv_data)) + pxa2xx_spi_update(drv_data, DDS_RATE, GENMASK(23, 0), chip->dds_rate); /* Stop the SSP */ if (!is_mmp2_ssp(drv_data)) @@ -1102,15 +1101,11 @@ static int pxa2xx_spi_transfer_one(struct spi_controller *controller, if (!pxa25x_ssp_comp(drv_data)) pxa2xx_spi_write(drv_data, SSTO, chip->timeout); + /* first set CR1 without interrupt and service enables */ + pxa2xx_spi_update(drv_data, SSCR1, change_mask, cr1); + /* see if we need to reload the config registers */ - if ((pxa2xx_spi_read(drv_data, SSCR0) != cr0) - || (pxa2xx_spi_read(drv_data, SSCR1) & change_mask) - != (cr1 & change_mask)) { - /* first set CR1 without interrupt and service enables */ - pxa2xx_spi_write(drv_data, SSCR1, cr1 & change_mask); - /* Update the other bits */ - pxa2xx_spi_write(drv_data, SSCR0, cr0); - } + pxa2xx_spi_update(drv_data, SSCR0, GENMASK(31, 0), cr0); /* Restart the SSP */ pxa_ssp_enable(drv_data->ssp); -- 2.30.2