Re: [PATCH v2 03/13] spi: dw: Add support for Pensando Elba SoC SPI

[Brad Larson <brad@xxxxxxxxxxx>]

On Mon, Mar 29, 2021 at 8:58 AM Mark Brown <broonie@xxxxxxxxxx> wrote:
>
> On Sun, Mar 28, 2021 at 06:59:28PM -0700, Brad Larson wrote:
>
> > @@ -56,7 +56,7 @@ struct dw_spi_mscc {
> >  /*
> >   * The Designware SPI controller (referred to as master in the documentation)
> >   * automatically deasserts chip select when the tx fifo is empty. The chip
> > - * selects then needs to be either driven as GPIOs or, for the first 4 using the
> > + * selects then needs to be either driven as GPIOs or, for the first 4 using
> >   * the SPI boot controller registers. the final chip select is an OR gate
> >   * between the Designware SPI controller and the SPI boot controller.
> >   */
>
> This is an unrelated fix, please send as a separate patch as covered in
> submitting-patches.rst.

I'll remove this.  Belongs in a trivial patch set.

> > @@ -237,6 +237,31 @@ static int dw_spi_canaan_k210_init(struct platform_device *pdev,
> >       return 0;
> >  }
> >
> > +static void dw_spi_elba_set_cs(struct spi_device *spi, bool enable)
> > +{
> > +     struct dw_spi *dws = spi_master_get_devdata(spi->master);
> > +
> > +     if (!enable) {
> > +             /*
> > +              * Using a GPIO-based chip-select, the DW SPI
> > +              * controller still needs its own CS bit selected
> > +              * to start the serial engine.  On Elba the specific
> > +              * CS doesn't matter to start the serial engine,
> > +              * so using CS0.
> > +              */
>
> Why does this comment only apply to one branch of the conditional?

It doesn't, I'll move it outside the conditional.