[PATCH v2 6/9] spi: tegra210-quad: Add support for hardware dummy cycles

[Sowjanya Komatineni <skomatineni@xxxxxxxxxx>]

Tegra Quad SPI controller hardware supports sending dummy cycles
after address bytes.

This patch adds this support.

Signed-off-by: Sowjanya Komatineni <skomatineni@xxxxxxxxxx>
---
 drivers/spi/spi-tegra210-quad.c | 22 +++++++++++++++++++++-
 1 file changed, 21 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-tegra210-quad.c b/drivers/spi/spi-tegra210-quad.c
index 624f395..1d1b125 100644
--- a/drivers/spi/spi-tegra210-quad.c
+++ b/drivers/spi/spi-tegra210-quad.c
@@ -124,6 +124,13 @@
 #define QSPI_DMA_TIMEOUT			(msecs_to_jiffies(1000))
 #define DEFAULT_QSPI_DMA_BUF_LEN		(64 * 1024)
 
+enum transfer_phase {
+	CMD_BYTE_XFER = 0,
+	ADDR_BYTES_XFER,
+	DATA_BYTES_XFER,
+	MAX_XFERS,
+};
+
 struct tegra_qspi_client_data {
 	int tx_clk_tap_delay;
 	int rx_clk_tap_delay;
@@ -857,6 +864,8 @@ static int tegra_qspi_start_transfer_one(struct spi_device *spi,
 
 	tqspi->command1_reg = command1;
 
+	tegra_qspi_writel(tqspi, QSPI_NUM_DUMMY_CYCLE(tqspi->dummy_cycles), QSPI_MISC_REG);
+
 	ret = tegra_qspi_flush_fifos(tqspi, false);
 	if (ret < 0)
 		return ret;
@@ -977,7 +986,7 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
 	struct spi_device *spi = msg->spi;
 	struct spi_transfer *xfer;
 	bool is_first_msg = true;
-	int ret;
+	int ret, xfer_phase = 0;
 
 	msg->status = 0;
 	msg->actual_length = 0;
@@ -987,6 +996,15 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
 	list_for_each_entry(xfer, &msg->transfers, transfer_list) {
 		u32 cmd1;
 
+		/*
+		 * Program dummy clock cycles in Tegra QSPI register only
+		 * during address transfer phase.
+		 */
+		if (xfer_phase == ADDR_BYTES_XFER)
+			tqspi->dummy_cycles = msg->dummy_cycles;
+		else
+			tqspi->dummy_cycles = 0;
+
 		reinit_completion(&tqspi->xfer_completion);
 
 		cmd1 = tegra_qspi_setup_transfer_one(spi, xfer, is_first_msg);
@@ -1018,6 +1036,7 @@ static int tegra_qspi_transfer_one_message(struct spi_master *master, struct spi
 		}
 
 		msg->actual_length += xfer->len;
+		xfer_phase++;
 
 complete_xfer:
 		if (ret < 0) {
@@ -1203,6 +1222,7 @@ static int tegra_qspi_probe(struct platform_device *pdev)
 	master->mode_bits = SPI_MODE_0 | SPI_MODE_3 | SPI_CS_HIGH |
 			    SPI_TX_DUAL | SPI_RX_DUAL | SPI_TX_QUAD | SPI_RX_QUAD;
 	master->bits_per_word_mask = SPI_BPW_MASK(32) | SPI_BPW_MASK(16) | SPI_BPW_MASK(8);
+	master->flags = SPI_MASTER_USES_HW_DUMMY_CYCLES;
 	master->setup = tegra_qspi_setup;
 	master->cleanup = tegra_qspi_cleanup;
 	master->transfer_one_message = tegra_qspi_transfer_one_message;
-- 
2.7.4