[PATCH v2 0/2] spi: spi-qcom-qspi: Avoid some per-transfer overhead

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Not to be confused with the similar series I posed for the _other_
Qualcomm SPI controller (spi-geni-qcom) [1], this one avoids the
overhead on the Quad SPI controller.

It's based atop the current Qualcomm tree including Rajendra's ("spi:
spi-qcom-qspi: Use OPP API to set clk/perf state").  As discussed in
individual patches, these could ideally land through the Qualcomm tree
with Mark's Ack.

Measuring:
* Before OPP / Interconnect patches reading all flash takes: ~3.4 seconds
* After OPP / Interconnect patches reading all flash takes: ~4.7 seconds
* After this patch reading all flash takes: ~3.3 seconds

[1] https://lore.kernel.org/r/20200702004509.2333554-1-dianders@xxxxxxxxxxxx
[2] https://lore.kernel.org/r/1593769293-6354-2-git-send-email-rnayak@xxxxxxxxxxxxxx

Changes in v2:
- Return error from runtime resume if dev_pm_opp_set_rate() fails.

Douglas Anderson (2):
  spi: spi-qcom-qspi: Avoid clock setting if not needed
  spi: spi-qcom-qspi: Set an autosuspend delay of 250 ms

 drivers/spi/spi-qcom-qspi.c | 43 ++++++++++++++++++++++++++++---------
 1 file changed, 33 insertions(+), 10 deletions(-)

-- 
2.27.0.383.g050319c2ae-goog




[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux