[PATCH 6/8] spi: rspi: Increase bit rate range for QSPI

[Geert Uytterhoeven <geert+renesas@xxxxxxxxx>]

Increase bit rate range for QSPI by extending the range of supported
dividers:
  1. QSPI supports a divider of 1, by setting SPBR to zero, increasing
     the upper limit from 48.75 to 97.5 MHz,
  2. Make use of the Bit Rate Frequency Division Setting field in
     Command Registers, to decrease the lower limit from 191 to 24 kbps.

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
 drivers/spi/spi-rspi.c | 18 +++++++++++++++---
 1 file changed, 15 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-rspi.c b/drivers/spi/spi-rspi.c
index ea3f2680d3c13e02..38c0cd7febabf114 100644
--- a/drivers/spi/spi-rspi.c
+++ b/drivers/spi/spi-rspi.c
@@ -334,14 +334,26 @@ static int rspi_rz_set_config_register(struct rspi_data *rspi, int access_size)
  */
 static int qspi_set_config_register(struct rspi_data *rspi, int access_size)
 {
-	int spbr;
+	unsigned long clksrc;
+	int brdv = 0, spbr;
 
 	/* Sets output mode, MOSI signal, and (optionally) loopback */
 	rspi_write8(rspi, rspi->sppcr, RSPI_SPPCR);
 
 	/* Sets transfer bit rate */
-	spbr = DIV_ROUND_UP(clk_get_rate(rspi->clk), 2 * rspi->speed_hz);
-	rspi_write8(rspi, clamp(spbr, 0, 255), RSPI_SPBR);
+	clksrc = clk_get_rate(rspi->clk);
+	if (rspi->speed_hz >= clksrc) {
+		spbr = 0;
+	} else {
+		spbr = DIV_ROUND_UP(clksrc, 2 * rspi->speed_hz);
+		while (spbr > 255 && brdv < 3) {
+			brdv++;
+			spbr = DIV_ROUND_UP(spbr, 2);
+		}
+		spbr = clamp(spbr, 0, 255);
+	}
+	rspi_write8(rspi, spbr, RSPI_SPBR);
+	rspi->spcmd |= SPCMD_BRDV(brdv);
 
 	/* Disable dummy transmission, set byte access */
 	rspi_write8(rspi, 0, RSPI_SPDCR);
-- 
2.17.1