Patchwork housekeeping for: spi-devel-general

[patchwork-bot+linux-spi@xxxxxxxxxx]

Latest series: [v8] mtd: spi-nor: add xSPI Octal DTR support (2020-05-22T22:40:24)
  Superseding: [v7] mtd: spi-nor: add xSPI Octal DTR support (2020-05-22T10:12:43):
    [v7,01/20] spi: spi-mem: allow specifying whether an op is DTR or not
    [v7,02/20] spi: spi-mem: allow specifying a command's extension
    [v7,03/20] spi: atmel-quadspi: reject DTR ops
    [v7,04/20] spi: spi-mtk-nor: reject DTR ops
    [v7,05/20] spi: mxic: Avoid endianness problems with 2-byte opcodes
    [v7,06/20] mtd: spi-nor: add support for DTR protocol
    [v7,07/20] mtd: spi-nor: sfdp: default to addr_width of 3 for configurable widths
    [v7,08/20] mtd: spi-nor: sfdp: prepare BFPT parsing for JESD216 rev D
    [v7,09/20] mtd: spi-nor: sfdp: get command opcode extension type from BFPT
    [v7,10/20] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table
    [v7,11/20] mtd: spi-nor: core: use dummy cycle and address width info from SFDP
    [v7,12/20] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode
    [v7,13/20] mtd: spi-nor: core: enable octal DTR mode when possible
    [v7,14/20] mtd: spi-nor: sfdp: do not make invalid quad enable fatal
    [v7,15/20] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
    [v7,16/20] mtd: spi-nor: core: perform a Soft Reset on shutdown
    [v7,17/20] mtd: spi-nor: core: disable Octal DTR mode on suspend.
    [v7,18/20] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h
    [v7,19/20] mtd: spi-nor: spansion: add support for Cypress Semper flash
    [v7,20/20] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode


-- 
Deet-doot-dot, I am a bot.
https://korg.wiki.kernel.org/userdoc/pwbot