Patchwork housekeeping for: spi-devel-general

[patchwork-bot+linux-spi@xxxxxxxxxx]

Latest series: [v6] mtd: spi-nor: add xSPI Octal DTR support (2020-05-20T16:30:35)
  Superseding: [v5] mtd: spi-nor: add xSPI Octal DTR support (2020-05-19T14:26:22):
    [v5,01/19] spi: spi-mem: allow specifying whether an op is DTR or not
    [v5,02/19] spi: atmel-quadspi: reject DTR ops
    [v5,03/19] spi: spi-mtk-nor: reject DTR ops
    [v5,04/19] spi: spi-mem: allow specifying a command's extension
    [v5,05/19] mtd: spi-nor: add support for DTR protocol
    [v5,06/19] mtd: spi-nor: sfdp: default to addr_width of 3 for configurable widths
    [v5,07/19] mtd: spi-nor: sfdp: prepare BFPT parsing for JESD216 rev D
    [v5,08/19] mtd: spi-nor: sfdp: get command opcode extension type from BFPT
    [v5,09/19] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table
    [v5,10/19] mtd: spi-nor: core: use dummy cycle and address width info from SFDP
    [v5,11/19] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode
    [v5,12/19] mtd: spi-nor: core: enable octal DTR mode when possible
    [v5,13/19] mtd: spi-nor: sfdp: do not make invalid quad enable fatal
    [v5,14/19] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT
    [v5,15/19] mtd: spi-nor: core: perform a Soft Reset on shutdown
    [v5,16/19] mtd: spi-nor: core: disable Octal DTR mode on suspend.
    [v5,17/19] mtd: spi-nor: core: expose spi_nor_default_setup() in core.h
    [v5,18/19] mtd: spi-nor: spansion: add support for Cypress Semper flash
    [v5,19/19] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode


-- 
Deet-doot-dot, I am a bot.
https://korg.wiki.kernel.org/userdoc/pwbot