Re: [PATCH 2/3] ARM: dts: stm32: enable l3gd20 on stm32429-disco board

[dillon min <dillon.minfei@xxxxxxxxx>]

Hi, Alexandre,

Thanks for review.

On Mon, May 11, 2020 at 3:17 PM Alexandre Torgue
<alexandre.torgue@xxxxxx> wrote:
>
> Hi
>
> On 5/9/20 8:58 AM, dillon.minfei@xxxxxxxxx wrote:
> > From: dillon min <dillon.minfei@xxxxxxxxx>
> >
> > Enable l3gd20 on stm32429-disco board.
>
> You could add some words about l3gd20
ok, thanks, i will add some description about l3gd20.
>
> >
> > Signed-off-by: dillon min <dillon.minfei@xxxxxxxxx>
> > ---
> >   arch/arm/boot/dts/stm32f429-disco.dts | 24 ++++++++++++++++++++++++
> >   1 file changed, 24 insertions(+)
> >
> > diff --git a/arch/arm/boot/dts/stm32f429-disco.dts b/arch/arm/boot/dts/stm32f429-disco.dts
> > index 30c0f67..d365358 100644
> > --- a/arch/arm/boot/dts/stm32f429-disco.dts
> > +++ b/arch/arm/boot/dts/stm32f429-disco.dts
> > @@ -49,6 +49,8 @@
> >   #include "stm32f429.dtsi"
> >   #include "stm32f429-pinctrl.dtsi"
> >   #include <dt-bindings/input/input.h>
> > +#include <dt-bindings/interrupt-controller/irq.h>
> > +#include <dt-bindings/gpio/gpio.h>
> >
> >   / {
> >       model = "STMicroelectronics STM32F429i-DISCO board";
> > @@ -127,3 +129,25 @@
> >       pinctrl-names = "default";
> >       status = "okay";
> >   };
> > +
> > +&spi5 {
> > +     status = "okay";
> > +     pinctrl-0 = <&spi5_pins>;
> > +     pinctrl-names = "default";
> > +     #address-cells = <1>;
> > +     #size-cells = <0>;
> > +     cs-gpios = <&gpioc 1 GPIO_ACTIVE_LOW>;
> > +     dmas = <&dma2 3 2 0x400 0x0>,
> > +            <&dma2 4 2 0x400 0x0>;
> > +     dma-names = "rx", "tx";
>
> Insert blank line here.
ok
>
> > +     l3gd20: l3gd20@0 {
> > +             compatible = "st,l3gd20-gyro";
> > +             spi-max-frequency = <10000000>;
> > +             st,drdy-int-pin = <2>;
> > +             interrupt-parent = <&gpioa>;
> > +             interrupts = <1 IRQ_TYPE_EDGE_RISING>,
> > +                             <2 IRQ_TYPE_EDGE_RISING>;
> > +             reg = <0>;
> > +             status = "okay";
> > +     };
> > +};
> >