Re: [PATCH v10 1/2] dt-bindings: spi: Add schema for Cadence QSPI Controller driver

["Ramuthevar, Vadivel MuruganX" <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx>]

Hi Rob,

     Thank you for the review comments...

On 24/2/2020 11:54 PM, Rob Herring wrote:
> On Tue, Feb 18, 2020 at 8:29 PM Ramuthevar,Vadivel MuruganX
> <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx> wrote:
> > From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx>
> Cc the DT list if you want this reviewed.
Sorry,  next patch will add DT list in CC.
> > Add dt-bindings documentation for Cadence-QSPI controller to support
> > spi based flash memories.
> >
> > Signed-off-by: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx>
> > ---
> >   .../devicetree/bindings/spi/cdns,qspi-nor.yaml     | 147 +++++++++++++++++++++
> >   1 file changed, 147 insertions(+)
> >   create mode 100644 Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
> >
> > diff --git a/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml b/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
> > new file mode 100644
> > index 000000000000..1a4d6e8d0d0b
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/spi/cdns,qspi-nor.yaml
> > @@ -0,0 +1,147 @@
> > +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
> > +%YAML 1.2
> > +---
> > +$id: "http://devicetree.org/schemas/spi/cdns,qspi-nor.yaml#";
> > +$schema: "http://devicetree.org/meta-schemas/core.yaml#";
> > +
> > +title: Cadence QSPI Flash Controller support
> > +
> > +maintainers:
> > +  - Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx>
> > +
> > +allOf:
> > +  - $ref: "spi-controller.yaml#"
> > +
> > +description: |
> > +  Binding Documentation for Cadence QSPI controller,This controller is
> > +  present in the Intel LGM, Altera SoCFPGA and TI SoCs and this driver
> > +  has been tested On Intel's LGM SoC.
> > +
> > +  - compatible : should be one of the following:
> > +        Generic default - "cdns,qspi-nor".
> > +        For TI 66AK2G SoC - "ti,k2g-qspi", "cdns,qspi-nor".
> > +        For TI AM654 SoC  - "ti,am654-ospi", "cdns,qspi-nor".
> > +        For Intel LGM SoC - "intel,lgm-qspi", "cdns,qspi-nor".
> > +
> > +properties:
> > +  compatible:
> > +    oneOf:
> > +      - items:
> > +        - enum:
> > +           - ti,k2g-qspi
> > +        - const: cdns,qspi-nor
> > +
> > +      - items:
> > +        - enum:
> > +           - ti,am654-ospi
> > +        - const: cdns,qspi-nor
> > +
> > +      - items:
> > +        - enum:
> > +           - intel,lgm-qspi
> > +        - const: cdns,qspi-nor
> > +
> > +      - items:
> > +        - const: cdns,qspi-nor
> > +
> > +  reg:
> > +    maxItems: 2
> > +
> > +  interrupts:
> > +    maxItems: 1
> > +
> > +  clocks:
> > +    maxItems: 1
> > +
> > +  cdns,fifo-depth:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      Size of the data FIFO in words.
> A 4GB fifo is valid? Add some constraints.
128 is valid, will update.
> > +
> > +  cdns,fifo-width:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      Bus width of the data FIFO in bytes.
> Add some constraints.
4 is valid , will fix it.
> > +
> > +  cdns,trigger-address:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      32-bit indirect AHB trigger address.
> > +
> > +  cdns,rclk-en:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description: |
> > +      Flag to indicate that QSPI return clock is used to latch the read data
> > +      rather than the QSPI clock. Make sure that QSPI return clock is populated
> > +      on the board before using this property.
> > +
> > +# subnode's properties
> > +patternProperties:
> > +  "^.*@[0-9a-fA-F]+$":
> > +    type: object
> > +    description:
> > +      flash device uses the subnodes below defined properties.
> > +
> > +  cdns,read-delay:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      Delay for read capture logic, in clock cycles.
> 4 billion clock delay is valid?
based on the ref_clk , will add it.
> > +
> > +  cdns,tshsl-ns:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> You can drop this, anything with a standard unit suffix already has a type.
sure , will drop it.
> > +    description: |
> > +      Delay in nanoseconds for the length that the master mode chip select
> > +      outputs are de-asserted between transactions.
> Constraints...?

50ns, will add it.

Regards
Vadivel
> > +
> > +  cdns,tsd2d-ns:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description: |
> > +      Delay in nanoseconds between one chip select being de-activated
> > +      and the activation of another.
> > +
> > +  cdns,tchsh-ns:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description: |
> > +      Delay in nanoseconds between last bit of current transaction and
> > +      deasserting the device chip select (qspi_n_ss_out).
> > +
> > +  cdns,tslch-ns:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description: |
> > +      Delay in nanoseconds between setting qspi_n_ss_out low and
> > +      first bit transfer.
> > +
> > +required:
> > +  - compatible
> > +  - reg
> > +  - interrupts
> > +  - clocks
> > +  - cdns,fifo-depth
> > +  - cdns,fifo-width
> > +  - cdns,trigger-address
> > +
> > +examples:
> > +  - |
> > +    qspi: spi@ff705000 {
> > +          compatible = "cdns,qspi-nor";
> > +          #address-cells = <1>;
> > +          #size-cells = <0>;
> > +          reg = <0xff705000 0x1000>,
> > +                <0xffa00000 0x1000>;
> > +          interrupts = <0 151 4>;
> > +          clocks = <&qspi_clk>;
> > +          cdns,fifo-depth = <128>;
> > +          cdns,fifo-width = <4>;
> > +          cdns,trigger-address = <0x00000000>;
> > +
> > +          flash0: n25q00@0 {
> > +              compatible = "jedec,spi-nor";
> > +              reg = <0x0>;
> > +              cdns,read-delay = <4>;
> > +              cdns,tshsl-ns = <50>;
> > +              cdns,tsd2d-ns = <50>;
> > +              cdns,tchsh-ns = <4>;
> > +              cdns,tslch-ns = <4>;
> > +          };
> > +    };
> > +
> > --
> > 2.11.0