Latest series: [v2] spi: pxa2xx: add driver enabling message (2019-04-10T09:47:04) Superseding: [v1] spi: pxa2xx: add driver enabling message (2019-04-08T15:22:44): [1/1] spi: pxa2xx: add driver enabling message Latest series: [v2] spi: tegra114: fix PIO transfer (2019-04-05T00:14:14) Superseding: [v1] spi: tegra114: fix PIO transfer (2019-03-27T05:56:22): [V1,01/26] spi: tegra114: fix PIO transfer [V1,02/26] spi: tegra114: clear packed bit for unpacked mode [V1,03/26] spi: tegra114: fix for unpacked mode transfers [V1,04/26] spi: tegra114: use packed mode for 32 bits per word [V1,05/26] spi: tegra114: use unpacked mode for below 4 byte transfers [V1,06/26] spi: tegra114: terminate dma and reset on transfer timeout [V1,07/26] spi: tegra114: flush fifos [V1,08/26] spi: tegra114: configure dma burst size to fifo trig level [V1,09/26] spi: tegra114: dump SPI registers during timeout [V1,10/26] spi: tegra114: avoid reset call in atomic context [V1,11/26] spi: tegra114: reset controller on probe [V1,12/26] spi: tegra114: add SPI_LSB_FIRST support [V1,13/26] spi: tegra114: add dual mode support [V1,14/26] spi: tegra114: add 3 wire transfer mode support [V1,15/26] spi: tegra114: set supported bits_per_word [V1,16/26] spi: tegra114: set bus number based on id [V1,17/26] spi: tegra114: add support for interrupt mask [V1,18/26] spi: tegra114: add support for hw based cs [V1,19/26] DT bindings: spi: add spi client device properties [V1,20/26] spi: tegra114: add support for tuning HW CS timing [V1,21/26] DT bindings: spi: add tx/rx clock delay SPI client properties [V1,22/26] spi: tegra114: add support for tuning clock delay [V1,23/26] spi: tegra114: add support for gpio based cs [V1,24/26] spi: tegra114: de-assert CS before SPI mode is reset to its default [V1,25/26] spi: expand mode and mode_bits support [V1,26/26] spi: tegra114: add support for LSBYTE_FIRST Latest series: [v3] dt-bindings: spi: Add YAML schemas for the generic SPI options (2019-05-20T14:50:34) Superseding: [v1] dt-bindings: spi: Add YAML schemas for the generic SPI options (2019-05-07T13:48:13): [1/4] dt-bindings: spi: Add YAML schemas for the generic SPI options [2/4] dt-bindings: spi: sun4i: Add YAML schemas [3/4] dt-bindings: spi: sun6i: Add YAML schemas [4/4] ARM: dts: sun6i: Add default address and size cells for SPI Superseding: [v2] dt-bindings: spi: Add YAML schemas for the generic SPI options (2019-05-09T07:26:05): [v2,1/4] dt-bindings: spi: Add YAML schemas for the generic SPI options [v2,2/4] dt-bindings: spi: sun4i: Add YAML schemas [v2,3/4] dt-bindings: spi: sun6i: Add YAML schemas [v2,4/4] ARM: dts: sun6i: Add default address and size cells for SPI Latest series: [v3] spi: spi-mem: Fix build error without CONFIG_SPI_MEM (2019-04-10T11:57:09) Superseding: [v2] spi: spi-mem: Fix build error without CONFIG_SPI_MEM (2019-04-10T05:44:45): [LINUX,v2] spi: spi-mem: Fix build error without CONFIG_SPI_MEM Latest series: [v2] spi: pxa2xx: fix SCR (divisor) calculation (2019-04-12T07:32:19) Superseding: [v1] spi: pxa2xx: fix SCR (divisor) calculation (2019-04-10T12:51:35): [1/2] spi: pxa2xx: fix SCR (divisor) calculation [2/2] spi: pxa2xx: use a module softdep for dw_dmac -- Deet-doot-dot, I am a bot. https://korg.wiki.kernel.org/userdoc/pwbot