Convert GPIO chip selects in the Renesas MSIOF SPI driver from legacy GPIO numbers to GPIO descriptors. Notes: - The board file for the SH7724-based Ecovec24 development board now registers a GPIO descriptor lookup, instead of passing a GPIO number through controller_data, - sh_msiof_get_cs_gpios() must release all GPIOs, else spi_get_gpio_descs() cannot claim them during SPI controller registration. Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx> --- sh_msiof_get_cs_gpios() still duplicates some logic from spi_get_gpio_descs(). Reusing spi_controller.cs_gpiods[] is not trivial, as that becomes available only after calling spi_register_controller(), when slave devices have already been set up. Alternatively, the functionality to find an unused native chip select (and assert that when talking to a GPIO-selected slave) could be moved to the core, under control of a new flag in spi_controller. To add complexity, some controllers may need unused_ss handling, but not native_cs_high handling. Tested on Ebisu-4D with R-Car E3 using a 25LC040 EEPROM connected to CN41. Compile-tested on SH (ecovec24_defconfig + CONFIG_MMC_SDHI=n). Testing on Ecovec24 would be appreciated. --- arch/sh/boards/mach-ecovec24/setup.c | 12 +++++++++--- drivers/spi/spi-sh-msiof.c | 20 ++++---------------- 2 files changed, 13 insertions(+), 19 deletions(-) diff --git a/arch/sh/boards/mach-ecovec24/setup.c b/arch/sh/boards/mach-ecovec24/setup.c index c4cdee5f4df413e2..acaa97459531c602 100644 --- a/arch/sh/boards/mach-ecovec24/setup.c +++ b/arch/sh/boards/mach-ecovec24/setup.c @@ -806,7 +806,6 @@ static struct spi_board_info spi_bus[] = { .platform_data = &mmc_spi_info, .max_speed_hz = 5000000, .mode = SPI_MODE_0, - .controller_data = (void *) GPIO_PTM4, }, }; @@ -838,6 +837,14 @@ static struct platform_device msiof0_device = { .resource = msiof0_resources, }; +static struct gpiod_lookup_table msiof_gpio_table = { + .dev_id = "spi_sh_msiof.0", + .table = { + GPIO_LOOKUP("sh7724_pfc", GPIO_PTM4, "cs", GPIO_ACTIVE_HIGH), + { }, + }, +}; + #endif /* FSI */ @@ -1296,12 +1303,11 @@ static int __init arch_setup(void) gpio_request(GPIO_FN_MSIOF0_TXD, NULL); gpio_request(GPIO_FN_MSIOF0_RXD, NULL); gpio_request(GPIO_FN_MSIOF0_TSCK, NULL); - gpio_request(GPIO_PTM4, NULL); /* software CS control of TSYNC pin */ - gpio_direction_output(GPIO_PTM4, 1); /* active low CS */ gpio_request(GPIO_PTB6, NULL); /* 3.3V power control */ gpio_direction_output(GPIO_PTB6, 0); /* disable power by default */ gpiod_add_lookup_table(&mmc_spi_gpio_table); + gpiod_add_lookup_table(&msiof_gpio_table); spi_register_board_info(spi_bus, ARRAY_SIZE(spi_bus)); #endif diff --git a/drivers/spi/spi-sh-msiof.c b/drivers/spi/spi-sh-msiof.c index d3794499915c17cb..6aab7b2136dbcadc 100644 --- a/drivers/spi/spi-sh-msiof.c +++ b/drivers/spi/spi-sh-msiof.c @@ -549,25 +549,11 @@ static void sh_msiof_spi_read_fifo_s32u(struct sh_msiof_spi_priv *p, static int sh_msiof_spi_setup(struct spi_device *spi) { - struct device_node *np = spi->controller->dev.of_node; struct sh_msiof_spi_priv *p = spi_controller_get_devdata(spi->controller); u32 clr, set, tmp; - if (!np) { - /* - * Use spi->controller_data for CS (same strategy as spi_gpio), - * if any. otherwise let HW control CS - */ - spi->cs_gpio = (uintptr_t)spi->controller_data; - } - - if (gpio_is_valid(spi->cs_gpio)) { - gpio_direction_output(spi->cs_gpio, !(spi->mode & SPI_CS_HIGH)); - return 0; - } - - if (spi_controller_is_slave(p->ctlr)) + if (spi->cs_gpiod || spi_controller_is_slave(p->ctlr)) return 0; if (p->native_cs_inited && @@ -600,7 +586,7 @@ static int sh_msiof_prepare_message(struct spi_controller *ctlr, u32 ss, cs_high; /* Configure pins before asserting CS */ - if (gpio_is_valid(spi->cs_gpio)) { + if (spi->cs_gpiod) { ss = p->unused_ss; cs_high = p->native_cs_high; } else { @@ -1156,6 +1142,7 @@ static int sh_msiof_get_cs_gpios(struct sh_msiof_spi_priv *p) gpiod = devm_gpiod_get_index(dev, "cs", i, GPIOD_ASIS); if (!IS_ERR(gpiod)) { + devm_gpiod_put(dev, gpiod); cs_gpios++; continue; } @@ -1407,6 +1394,7 @@ static int sh_msiof_spi_probe(struct platform_device *pdev) ctlr->bits_per_word_mask = chipdata->bits_per_word_mask; ctlr->auto_runtime_pm = true; ctlr->transfer_one = sh_msiof_transfer_one; + ctlr->use_gpio_descriptors = true; ret = sh_msiof_request_dma(p); if (ret < 0) -- 2.17.1