[PATCH 4/5] spi: bcm2835: support effective_speed_hz

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Martin Sperl <kernel@xxxxxxxxxxxxxxxx>

Setting spi_transfer->effective_speed_hz in transfer_one so that
it can get used in cs_change_delay configured with delay as a muliple
of SPI clock cycles.

Signed-off-by: Martin Sperl <kernel@xxxxxxxxxxxxxxxx>
---
 drivers/spi/spi-bcm2835.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/spi-bcm2835.c b/drivers/spi/spi-bcm2835.c
index 35aebdfd3b4e..c2912c1e09c5 100644
--- a/drivers/spi/spi-bcm2835.c
+++ b/drivers/spi/spi-bcm2835.c
@@ -777,7 +777,6 @@ static int bcm2835_spi_transfer_one(struct spi_master *master,
 {
 	struct bcm2835_spi *bs = spi_master_get_devdata(master);
 	unsigned long spi_hz, clk_hz, cdiv;
-	unsigned long spi_used_hz;
 	unsigned long long xfer_time_us;
 	u32 cs = bcm2835_rd(bs, BCM2835_SPI_CS);

@@ -797,7 +796,7 @@ static int bcm2835_spi_transfer_one(struct spi_master *master,
 	} else {
 		cdiv = 0; /* 0 is the slowest we can go */
 	}
-	spi_used_hz = cdiv ? (clk_hz / cdiv) : (clk_hz / 65536);
+	tfr->effective_speed_hz = cdiv ? (clk_hz / cdiv) : (clk_hz / 65536);
 	bcm2835_wr(bs, BCM2835_SPI_CLK, cdiv);

 	/* handle all the 3-wire mode */
@@ -823,7 +822,7 @@ static int bcm2835_spi_transfer_one(struct spi_master *master,
 	xfer_time_us = (unsigned long long)tfr->len
 		* 9 /* clocks/byte - SPI-HW waits 1 clock after each byte */
 		* 1000000;
-	do_div(xfer_time_us, spi_used_hz);
+	do_div(xfer_time_us, tfr->effective_speed_hz);

 	/* for short requests run polling*/
 	if (xfer_time_us <= BCM2835_SPI_POLLING_LIMIT_US)
--
2.11.0



[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux