Re: [PATCH 0/5] Prepare devicetrees for the new FSL QSPI driver

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



+ Shawn, Sascha

On 10.12.18 17:31, Schrempf Frieder wrote:
> Hi FSL/ARM maintainers,
> 
> On 10.12.18 17:26, Schrempf Frieder wrote:
>> From: Frieder Schrempf <frieder.schrempf@xxxxxxxxxx>
>>
>> We have prepared a new driver for the FSL QSPI controller that works under
>> the SPI framework. The current devicetrees are broken because they use an
>> inconsistent scheme for assigning the reg properties.
>>
>> As, in contrast to the current driver, the new driver will use the reg
>> properties to select the correct chip, we need to fix them.
>>
>> We also add spi-[tx/rx]-bus-width to make sure the full buswidth will be used
>> and while at it clean up and remove some unused properties.
> 
> could you please consider these devicetree patches for v4.21?

Any chance to get this merged? Otherwise we would need to postpone the 
new driver even further.

All the changes to the devicetrees in this series are non-intrusive and 
uncritical, anyway.

Thanks,
Frieder

> 
> We have the new FSL QSPI driver under the SPI framework ([1]) ready, but
> we need some small fixes to the devicetrees that are currently broken.
> 
> As the new driver depends on these changes (mainly the change to the reg
> properties) and it is not possible to add compatibility for the old
> bindings, it would be really nice to have them in v4.21, so we can queue
> the driver for v4.22 or whatever the next release will be called.
> 
> Please also see [2] for some more explanation.
> 
> Thanks,
> Frieder
> 
> [1] https://patchwork.ozlabs.org/cover/1007641/
> [2] https://patchwork.ozlabs.org/patch/922817/#1925445
> 
>>
>> Frieder Schrempf (5):
>>     arm64: dts: Remove unused properties from FSL QSPI driver nodes
>>     ARM: dts: Remove unused properties from FSL QSPI driver nodes
>>     ARM: dts: imx6sx-sdb: Fix the reg properties for the FSL QSPI nodes
>>     arm64: dts: Add spi-[tx/rx]-bus-width for the FSL QSPI controller
>>     ARM: dts: Add spi-[tx/rx]-bus-width for the FSL QSPI controller
>>
>>    arch/arm/boot/dts/imx6sx-sdb-reva.dts              | 8 ++++++--
>>    arch/arm/boot/dts/imx6sx-sdb.dts                   | 8 ++++++--
>>    arch/arm/boot/dts/imx6ul-14x14-evk.dtsi            | 2 ++
>>    arch/arm/boot/dts/ls1021a-moxa-uc-8410a.dts        | 5 ++---
>>    arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dts  | 3 ++-
>>    arch/arm64/boot/dts/freescale/fsl-ls1046a-qds.dts  | 4 ++--
>>    arch/arm64/boot/dts/freescale/fsl-ls1046a-rdb.dts  | 6 ++++--
>>    arch/arm64/boot/dts/freescale/fsl-ls208xa-qds.dtsi | 4 ++++
>>    8 files changed, 28 insertions(+), 12 deletions(-)
>>
> ______________________________________________________
> Linux MTD discussion mailing list
> http://lists.infradead.org/mailman/listinfo/linux-mtd/
> 




[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux