Re: [PATCH 2/3] dt-bindings: mfd: atmel-usart: add DMA bindings for SPI mode

[Radu Nicolae Pirea <radu_nicolae.pirea@xxxxxx>]

On Wed, 2018-11-21 at 10:41 -0600, Rob Herring wrote:
> On Wed, Nov 21, 2018 at 5:29 AM Radu Pirea <radu_nicolae.pirea@xxxxxx
> > wrote:
> > The bindings for DMA are now common for both drivers of the USART
> > IP.
> > 
> > The node given as an example for USART in SPI mode has been updated
> > in
> > order to include DMA bindings.
> > 
> > Signed-off-by: Radu Pirea <radu_nicolae.pirea@xxxxxx>
> > ---
> >  .../devicetree/bindings/mfd/atmel-usart.txt       | 15 ++++++++++-
> > ----
> >  1 file changed, 10 insertions(+), 5 deletions(-)
> > 
> > diff --git a/Documentation/devicetree/bindings/mfd/atmel-usart.txt
> > b/Documentation/devicetree/bindings/mfd/atmel-usart.txt
> > index 7f0cd72f47d2..8ad008175343 100644
> > --- a/Documentation/devicetree/bindings/mfd/atmel-usart.txt
> > +++ b/Documentation/devicetree/bindings/mfd/atmel-usart.txt
> > @@ -17,17 +17,19 @@ Required properties for USART in SPI mode:
> >  - cs-gpios: chipselects (internal cs not supported)
> >  - atmel,usart-mode : Must be <AT91_USART_MODE_SPI> (found in dt-
> > bindings/mfd/at91-usart.h)
> > 
> > +Optional properties in serial and SPI mode:
> > +- dma bindings for dma transfer:
> > +       - dmas: DMA specifier, consisting of a phandle to DMA
> > controller node,
> > +               memory peripheral interface and USART DMA channel
> > ID, FIFO configuration.
> > +               Refer to dma.txt and atmel-dma.txt for details.
> > +       - dma-names: "rx" for RX channel, "tx" for TX channel.
> > +               dma-names = "tx", "rx";
> 
> The dma-names should have a defined order.

Thanks Rob.
I will specify in bindings a fixed order for dmas and dma-names.

> 
> Rob