[PATCH V2 5/5] spi: lpspi: CLK pin becomes low when CR_RST=1

[Clark Wang <xiaoning.wang@xxxxxxx>]

Remove Reset operation in fsl_lpspi_config(). This RST may cause both CLK
and CS pins go from high to low level under cs-gpio mode.
Add fsl_lpspi_reset() function after one message transfer to clear all
flags in use.

Signed-off-by: Xiaoning Wang <xiaoning.wang@xxxxxxx>
Reviewed-by: Fugang Duan <fugang.duan@xxxxxxx>
---
V2:
 - Wrong place to remove fsl_lpspi_txfifo_empty() code when I split patch
   from my work git tree Although the final code which after applying all
   these five patches is correct.
---
 drivers/spi/spi-fsl-lpspi.c | 21 +++++++++++++++++----
 1 file changed, 17 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-fsl-lpspi.c b/drivers/spi/spi-fsl-lpspi.c
index 1be29daa9f92..3a7fe1c83aaa 100644
--- a/drivers/spi/spi-fsl-lpspi.c
+++ b/drivers/spi/spi-fsl-lpspi.c
@@ -282,10 +282,6 @@ static int fsl_lpspi_config(struct fsl_lpspi_data *fsl_lpspi)
 	u32 temp;
 	int ret;
 
-	temp = CR_RST;
-	writel(temp, fsl_lpspi->base + IMX7ULP_CR);
-	writel(0, fsl_lpspi->base + IMX7ULP_CR);
-
 	if (!fsl_lpspi->is_slave) {
 		ret = fsl_lpspi_set_bitrate(fsl_lpspi);
 		if (ret)
@@ -376,6 +372,21 @@ static int fsl_lpspi_wait_for_completion(struct spi_controller *controller)
 	return 0;
 }
 
+static int fsl_lpspi_reset(struct fsl_lpspi_data *fsl_lpspi)
+{
+	u32 temp;
+
+	/* W1C for all flags in SR */
+	temp = 0x3F << 8;
+	writel(temp, fsl_lpspi->base + IMX7ULP_SR);
+
+	/* Clear FIFO and disable module */
+	temp = CR_RRF | CR_RTF;
+	writel(temp, fsl_lpspi->base + IMX7ULP_CR);
+
+	return 0;
+}
+
 static int fsl_lpspi_transfer_one(struct spi_controller *controller,
 				  struct spi_device *spi,
 				  struct spi_transfer *t)
@@ -397,6 +408,8 @@ static int fsl_lpspi_transfer_one(struct spi_controller *controller,
 	if (ret)
 		return ret;
 
+	fsl_lpspi_reset(fsl_lpspi);
+
 	return 0;
 }
 
-- 
2.17.1