Applied "spi/spi-pxa2xx: add PXA2xx SSP SPI Controller" to the spi tree

[Mark Brown <broonie@xxxxxxxxxx>]

The patch

   spi/spi-pxa2xx: add PXA2xx SSP SPI Controller

has been applied to the spi tree at

   https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git 

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.  

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark

>From 44221ebae2da9daad053e383240d8aeacacaa43e Mon Sep 17 00:00:00 2001
From: Lubomir Rintel <lkundrak@xxxxx>
Date: Wed, 10 Oct 2018 19:09:26 +0200
Subject: [PATCH] spi/spi-pxa2xx: add PXA2xx SSP SPI Controller

This is the SPI controller found on Marvel MMP2 and perhaps more
platforms.

Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
Signed-off-by: Lubomir Rintel <lkundrak@xxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
---
 .../devicetree/bindings/spi/spi-pxa2xx.txt    | 24 +++++++++++++++++++
 1 file changed, 24 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/spi/spi-pxa2xx.txt

diff --git a/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt b/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt
new file mode 100644
index 000000000000..0335a9bd2e8a
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/spi-pxa2xx.txt
@@ -0,0 +1,24 @@
+PXA2xx SSP SPI Controller
+
+Required properties:
+- compatible: Must be "marvell,mmp2-ssp".
+- reg: Offset and length of the device's register set.
+- interrupts: Should be the interrupt number.
+- clocks: Should contain a single entry describing the clock input.
+- #address-cells:  Number of cells required to define a chip select address.
+- #size-cells: Should be zero.
+
+Optional properties:
+- cs-gpios: list of GPIO chip selects. See the SPI bus bindings,
+  Documentation/devicetree/bindings/spi/spi-bus.txt
+
+Child nodes represent devices on the SPI bus
+  See ../spi/spi-bus.txt
+
+Example:
+	ssp1: spi@d4035000 {
+		compatible = "marvell,mmp2-ssp";
+		reg = <0xd4035000 0x1000>;
+		clocks = <&soc_clocks MMP2_CLK_SSP0>;
+		interrupts = <0>;
+	};
-- 
2.19.0.rc2