From: Lanqing Liu <lanqing.liu@xxxxxxxxxxxxxx> This patch adds the binding documentation for Spreadtrum SPI controller device. Signed-off-by: Lanqing Liu <lanqing.liu@xxxxxxxxxxxxxx> Signed-off-by: Baolin Wang <baolin.wang@xxxxxxxxxx> --- Documentation/devicetree/bindings/spi/spi-sprd.txt | 31 ++++++++++++++++++++ 1 file changed, 31 insertions(+) create mode 100644 Documentation/devicetree/bindings/spi/spi-sprd.txt diff --git a/Documentation/devicetree/bindings/spi/spi-sprd.txt b/Documentation/devicetree/bindings/spi/spi-sprd.txt new file mode 100644 index 0000000..06ff746 --- /dev/null +++ b/Documentation/devicetree/bindings/spi/spi-sprd.txt @@ -0,0 +1,31 @@ +Spreadtrum SPI Controller + +Required properties: +- compatible: Should be "sprd,sc9860-spi". +- reg: Offset and length of SPI controller register space. +- interrupts: Should contain SPI interrupt. +- clock-names: Should contain following entries: + "spi" for SPI clock, + "source" for SPI source (parent) clock, + "enable" for SPI module enable clock. +- clocks: List of clock input name strings sorted in the same order + as the clock-names property. +- #address-cells: The number of cells required to define a chip select + address on the SPI bus. Should be set to 1. +- #size-cells: Should be set to 0. + +Optional properties: +- sprd,spi-interval: Specify the intervals of two SPI frames, which can be + converted to the delay clock cycles = interval number * 4 + 10. + +Example: +spi0: spi@70a00000{ + compatible = "sprd,sc9860-spi"; + reg = <0 0x70a00000 0 0x1000>; + interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>; + clock-names = "spi", "source","enable"; + clocks = <&clk_spi0>, <&ext_26m>, <&clk_ap_apb_gates 5>; + sprd,spi-interval = <9>; + #address-cells = <1>; + #size-cells = <0>; +}; -- 1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html