The spi device mode should be configured in the controller before the chip-select is asserted, so that a clock polarity configuration change is not interpreted as a clock tick by the device. This patch moves the mode setting to the 'prepare_message' function instead of the 'transfer_one' function. By doing so, this patch also removes redundant code in a3700_spi_clock_set. This was tested on EspressoBin board, with spidev. Signed-off-by: Maxime Chevallier <maxime.chevallier@xxxxxxxx> --- drivers/spi/spi-armada-3700.c | 17 ++++------------- 1 file changed, 4 insertions(+), 13 deletions(-) diff --git a/drivers/spi/spi-armada-3700.c b/drivers/spi/spi-armada-3700.c index 568e1c6..77fe55c 100644 --- a/drivers/spi/spi-armada-3700.c +++ b/drivers/spi/spi-armada-3700.c @@ -213,7 +213,7 @@ static void a3700_spi_mode_set(struct a3700_spi *a3700_spi, } static void a3700_spi_clock_set(struct a3700_spi *a3700_spi, - unsigned int speed_hz, u16 mode) + unsigned int speed_hz) { u32 val; u32 prescale; @@ -231,17 +231,6 @@ static void a3700_spi_clock_set(struct a3700_spi *a3700_spi, val |= A3700_SPI_CLK_CAPT_EDGE; spireg_write(a3700_spi, A3700_SPI_IF_TIME_REG, val); } - - val = spireg_read(a3700_spi, A3700_SPI_IF_CFG_REG); - val &= ~(A3700_SPI_CLK_POL | A3700_SPI_CLK_PHA); - - if (mode & SPI_CPOL) - val |= A3700_SPI_CLK_POL; - - if (mode & SPI_CPHA) - val |= A3700_SPI_CLK_PHA; - - spireg_write(a3700_spi, A3700_SPI_IF_CFG_REG, val); } static void a3700_spi_bytelen_set(struct a3700_spi *a3700_spi, unsigned int len) @@ -423,7 +412,7 @@ static void a3700_spi_transfer_setup(struct spi_device *spi, a3700_spi = spi_master_get_devdata(spi->master); - a3700_spi_clock_set(a3700_spi, xfer->speed_hz, spi->mode); + a3700_spi_clock_set(a3700_spi, xfer->speed_hz); byte_len = xfer->bits_per_word >> 3; @@ -584,6 +573,8 @@ static int a3700_spi_prepare_message(struct spi_master *master, a3700_spi_bytelen_set(a3700_spi, 4); + a3700_spi_mode_set(a3700_spi, spi->mode); + return 0; } -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html