Re: [PATCH 2/2] spi: imx: fix use of native chip-selects with devicetree

[Shawn Guo <shawnguo@xxxxxxxxxx>]

On Fri, Mar 17, 2017 at 03:03:03PM +1000, Greg Ungerer wrote:
> The commonly used mechanism of specifying the hardware or native
> chip-select on an SPI device in devicetree (that is "cs-gpios = <0>")
> does not result in the native chip-select being configured for use.
> So external SPI devices that require use of the native chip-select
> will not work.
> 
> You can successfully specify native chip-selects if using a platform
> setup by specifying the cs-gpio as negative offset by 32. And that
> works correctly. You cannot use the same method in devicetree.
> 
> The logic in the spi-imx.c driver during probe uses core spi function
> of_spi_register_master() in spi.c to parse the "cs-gpios" devicetree tag.
> For valid GPIO values that will be recorded for use, all other entries in
> the cs_gpios list will be set to -ENOENT. So entries like "<0>" will be
> set to -ENOENT in the cs_gpios list.
> 
> When the SPI device registers are setup the code will use the GPIO
> listed in the cs_gpios list for the desired chip-select. If the cs_gpio
> is less then 0 then it is intended to be for a native chip-select, and
> its cs_gpio value is added to 32 to get the chipselect number to use.
> Problem is that with devicetree this can only ever be -ENOENT (which
> is -2), and that alone results in an invalid chip-select number. But also
> doesn't allow selection of the native chip-select at all.
> 
> To fix, if the cs_gpio specified for this spi device is not a
> valid GPIO then use the "chip_select" (that is the native chip-select
> number) for hardware setup.
> 
> Signed-off-by: Greg Ungerer <gerg@xxxxxxxxxxxxxx>

Acked-by: Shawn Guo <shawnguo@xxxxxxxxxx>
--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html