On 2016-11-17 04:16, Sanchayan Maity wrote: > Currently dmaengine_prep_slave_single was being called with length > set to the complete DMA buffer size. This resulted in unwanted bytes > being transferred to the SPI register leading to clock and MOSI lines > having unwanted data even after chip select got deasserted and the > required bytes having been transferred. > > Signed-off-by: Sanchayan Maity <maitysanchayan@xxxxxxxxx> > --- > drivers/spi/spi-fsl-dspi.c | 10 ++++++++-- > 1 file changed, 8 insertions(+), 2 deletions(-) > > diff --git a/drivers/spi/spi-fsl-dspi.c b/drivers/spi/spi-fsl-dspi.c > index b1ee1f5..aee8c88 100644 > --- a/drivers/spi/spi-fsl-dspi.c > +++ b/drivers/spi/spi-fsl-dspi.c > @@ -265,7 +265,10 @@ static int dspi_next_xfer_dma_submit(struct fsl_dspi *dspi) > > dma->tx_desc = dmaengine_prep_slave_single(dma->chan_tx, > dma->tx_dma_phys, > - DSPI_DMA_BUFSIZE, DMA_MEM_TO_DEV, > + dma->curr_xfer_len * > + DMA_SLAVE_BUSWIDTH_4_BYTES / > + (tx_word ? 2 : 1), > + DMA_MEM_TO_DEV, Hm, this is getting ridiculous, I think we convert curr_xfer_len from bytes to DMA transfers in almost every use. Can we make it be transfer length in actual 4 byte transfers? We then probably have to convert it to bytes once to subtract from curr_remaining_bytes, but I think it would simplify code overall... -- Stefan > DMA_PREP_INTERRUPT | DMA_CTRL_ACK); > if (!dma->tx_desc) { > dev_err(dev, "Not able to get desc for DMA xfer\n"); > @@ -281,7 +284,10 @@ static int dspi_next_xfer_dma_submit(struct fsl_dspi *dspi) > > dma->rx_desc = dmaengine_prep_slave_single(dma->chan_rx, > dma->rx_dma_phys, > - DSPI_DMA_BUFSIZE, DMA_DEV_TO_MEM, > + dma->curr_xfer_len * > + DMA_SLAVE_BUSWIDTH_4_BYTES / > + (tx_word ? 2 : 1), > + DMA_DEV_TO_MEM, > DMA_PREP_INTERRUPT | DMA_CTRL_ACK); > if (!dma->rx_desc) { > dev_err(dev, "Not able to get desc for DMA xfer\n"); -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html