On Tuesday, May 31, 2016 07:06 PM, Sascha Hauer wrote:
On Tue, May 31, 2016 at 07:43:37AM -0300, Fabio Estevam wrote:
[Adding Sascha and Anton in Cc]
On Tue, May 31, 2016 at 6:40 AM, Chris Ruehl <chris.ruehl@xxxxxxxxxxxx> wrote:
Hi,
as imx6 using multiple burst to send data to spi slaves and drop the
chipselect between the words by default my sensor NXP MPL115A1 wasn't
working.
I generally recommend to use GPIO Chip selects. The SPI controller has
its own ideas when to assert the chipselects which is hard to match (if
possible at all) with what Linux SPI expects. See the cs-gpios device
tree property.
Sascha
Sascha that's a good approach to fight this problem, if you have the
choice. Sadly my hardware design is finished and I can only switch to
a gpio by run wires on the finished PCB.. and that's not what I want.
With the single burst mode patch, the logic analyser shows a very nice and
and clean and accurate chipselect clock MOSI and MISO.
Chris
--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
