Wenyou Yang <wenyou.yang@xxxxxxxxx> writes: > Replace the deprecated master->transfer with transfer_one_message() > and allow the SPI subsystem handle all the queuing of messages. > > Signed-off-by: Wenyou Yang <wenyou.yang@xxxxxxxxx> > Tested-by: Richard Genoud <richard.genoud@xxxxxxxxx> > --- > Hi Mark, > > Thanks for your feedback. > > According to your advice, I prepared this version 2. > > The patch is based on the for-next branch of > git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git > > I tested it on sama5d3xek and at91sam9m10g45ek board. > Richard helped tested it on at91sam9g35-ek board. > > Best Regards, > Wenyou Yang > > v2 changelog: > 1./ Rebase the latest for-next branch included the patch from Richard. > 2./ remove the lock on complete(&as->xfer_completion). > 3./ rework the xfer->cs_change is true. > 4./ remove the member stopping of struct atmel_spi. > > drivers/spi/spi-atmel.c | 678 +++++++++++++++-------------------------------- > 1 file changed, 220 insertions(+), 458 deletions(-) This patch broke the display control on the AT32STK1000 board. I don't know which part of the patch is causing the problem. This shows up in the kernel log (with debug messages enabled): atmel_spi atmel_spi.0: version: 0x171 atmel_spi atmel_spi.0: Atmel SPI Controller at 0xffe00000 (irq 3) spi spi0.0: setup: bpw 8 mode 0x1 -> csr0 00000008 spi spi0.1: setup: bpw 8 mode 0x3 -> csr1 00000009 ltv350qv spi0.1: new message 93c29cb4 submitted for spi0.1 ltv350qv spi0.1: activate 1, mr 000e0011 ltv350qv spi0.1: start xfer 93c29c78: len 3 tx 93c69ccc/13c69ccc rx (null)/ffffffff ------------[ cut here ]------------ WARNING: at drivers/spi/spi-atmel.c:1351 CPU: 0 PID: 1 Comm: swapper Not tainted 4.4.0-rc8+ #14 task: 93c1e000 ti: 93c28000 task.ti: 93c28000 PC is at atmel_spi_transfer_one_message+0x33a/0x72c LR is at schedule_timeout+0x72/0xc0 pc : [<90139a26>] lr : [<901d44b6>] Not tainted sp : 93c29b2c r12: 00000000 r11: 93d1adb8 r10: 93c1e364 r9 : 00000200 r8 : 00400022 r7 : 93d12dfc r6 : 93d12dfc r5 : 93c29c78 r4 : 93c29bb8 r3 : 93c29cb4 r2 : 93d12c00 r1 : 00000000 r0 : 00000000 Flags: qvnZc Mode bits: hjmde....G CPU Mode: Supervisor Call trace: [<900ebfea>] ida_get_new_above+0x5a/0x148 [<900ec07e>] ida_get_new_above+0xee/0x148 [<900efa96>] put_dec+0xa2/0xbc [<900efdea>] number+0x2e6/0x2f4 [<90137e6a>] __spi_pump_messages+0x21e/0x304 [<90137910>] spi_queued_transfer+0x0/0x8 [<90138046>] __spi_sync+0xf6/0xf8 [<90137910>] spi_queued_transfer+0x0/0x8 [<90138056>] spi_sync+0x6/0x8 [<9010a39e>] ltv350qv_write_reg+0x100/0x106 [<90080000>] __generic_block_fiemap+0x78/0x250 [<90138150>] spi_complete+0x0/0x8 [<9010a3cc>] ltv350qv_power+0x28/0x1e4 [<9010a5f6>] ltv350qv_probe+0x4e/0x68 [<90136b68>] spi_drv_probe+0x20/0x22 [<901336e6>] driver_probe_device+0xe6/0x188 [<90133826>] __device_attach_driver+0x4a/0x54 [<901327ae>] bus_for_each_drv+0x32/0x54 [<901337dc>] __device_attach_driver+0x0/0x54 [<901338a2>] __device_attach+0x5a/0x7c [<901338ca>] device_initial_probe+0x6/0x8 [<90132e2c>] bus_probe_device+0x58/0x5c [<90131d94>] device_add+0x1fc/0x344 [<9013823c>] spi_setup+0x88/0xf8 [<90139e18>] atmel_spi_setup+0x0/0x160 [<901386e8>] spi_add_device+0x70/0xf0 [<9013881e>] spi_new_device+0x56/0x6c [<9013884e>] spi_match_master_to_boardinfo+0x1a/0x30 [<90138938>] spi_register_master+0xd4/0x22c [<90138aac>] devm_spi_register_master+0x1c/0x44 [<90138faa>] atmel_spi_probe+0x29a/0x38c [<900b06c0>] sysfs_do_create_link_sd+0x34/0x60 [<90134430>] platform_drv_probe+0x14/0x40 [<901336e6>] driver_probe_device+0xe6/0x188 [<900ecbca>] kobject_add_internal+0x56/0x1c8 [<901337d8>] __driver_attach+0x50/0x54 [<90000418>] repair_env_string+0x0/0x58 [<9013280e>] bus_for_each_dev+0x3e/0x58 [<90133788>] __driver_attach+0x0/0x54 [<90133508>] driver_attach+0x10/0x14 [<90132cb2>] bus_add_driver+0xf6/0x15c [<90133aae>] driver_register+0x3e/0x98 [<901343b6>] __platform_driver_register+0x22/0x28 [<9000aba8>] atmel_spi_driver_init+0x0/0x10 [<9000abb2>] atmel_spi_driver_init+0xa/0x10 [<9000023e>] do_one_initcall+0xaa/0x130 [<90027ae2>] parse_args+0x19e/0x27c [<90000418>] repair_env_string+0x0/0x58 [<90000374>] kernel_init_freeable+0x88/0x12c [<90000382>] kernel_init_freeable+0x96/0x12c [<90000418>] repair_env_string+0x0/0x58 [<901d2588>] kernel_init+0x8/0xa4 [<90013130>] syscall_return+0x0/0x12 [<901d2580>] kernel_init+0x0/0xa4 [<90013130>] syscall_return+0x0/0x12 ---[ end trace 6b6391f8ee24f957 ]--- ltv350qv spi0.1: spi transfer timeout atmel_spi atmel_spi.0: overrun (2/3 remaining) atmel_spi atmel_spi.0: timeout waiting for TXEMPTY -- Måns Rullgård -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html