On 30.09.2015 10:42, Robin Gong wrote: > On Fri, Sep 25, 2015 at 07:57:12PM +0200, Anton Bondarenko wrote: >> @@ -370,8 +374,12 @@ static int __maybe_unused mx51_ecspi_config(struct spi_imx_data *spi_imx, >> if (config->mode & SPI_CS_HIGH) >> cfg |= MX51_ECSPI_CONFIG_SSBPOL(config->cs); >> >> + if (config->mode & SPI_LOOP) >> + lpb |= MX51_ECSPI_LOOP; >> + >> writel(ctrl, spi_imx->base + MX51_ECSPI_CTRL); >> writel(cfg, spi_imx->base + MX51_ECSPI_CONFIG); >> + writel(lpb, spi_imx->base + MX51_ECSPI_TEST); > It's better write this MX51_ECSPI_TEST only in LOOP mode. LOOP mode can be set dynamically. This mean we should be able to set and clear the flag. Currently only LOOP flag is used. I did not find any problems with writing 0 in the rest fields of TEST register. >> >> /* >> * Wait until the changes in the configuration register CONFIGREG >> @@ -1276,12 +1287,13 @@ static int spi_imx_probe(struct platform_device *pdev) >> spi_imx->bitbang.master->cleanup = spi_imx_cleanup; >> spi_imx->bitbang.master->prepare_message = spi_imx_prepare_message; >> spi_imx->bitbang.master->unprepare_message = spi_imx_unprepare_message; >> - spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH; >> + spi_imx->bitbang.master->mode_bits = SPI_CPOL | SPI_CPHA | >> + SPI_CS_HIGH; > Any change? Will be fixed in V3 >> >> - init_completion(&spi_imx->xfer_done); >> + if (is_imx5x_ecspi(spi_imx)) >> + spi_imx->bitbang.master->mode_bits |= SPI_LOOP; >> >> - spi_imx->devtype_data = of_id ? of_id->data : >> - (struct spi_imx_devtype_data *) pdev->id_entry->driver_data; >> + init_completion(&spi_imx->xfer_done); >> >> res = platform_get_resource(pdev, IORESOURCE_MEM, 0); >> spi_imx->base = devm_ioremap_resource(&pdev->dev, res); >> -- >> 2.5.2 >> -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html