This patch adds support of dual parallel mode configuration for Zynq Ultrascale+ MPSoC GQSPI controller driver. Signed-off-by: Ranjit Waghmode <ranjit.waghmode@xxxxxxxxxx> --- V2 Changes: - No change in this patch --- drivers/spi/spi-zynqmp-gqspi.c | 24 +++++++++++++++++++++++- 1 file changed, 23 insertions(+), 1 deletion(-) diff --git a/drivers/spi/spi-zynqmp-gqspi.c b/drivers/spi/spi-zynqmp-gqspi.c index f23f36e..7a72781 100644 --- a/drivers/spi/spi-zynqmp-gqspi.c +++ b/drivers/spi/spi-zynqmp-gqspi.c @@ -153,6 +153,7 @@ enum mode_type {GQSPI_MODE_IO, GQSPI_MODE_DMA}; * @dma_rx_bytes: Remaining bytes to receive by DMA mode * @dma_addr: DMA address after mapping the kernel buffer * @genfifoentry: Used for storing the genfifoentry instruction. + * @isinstr: To determine whether the transfer is instruction * @mode: Defines the mode in which QSPI is operating */ struct zynqmp_qspi { @@ -170,6 +171,7 @@ struct zynqmp_qspi { u32 dma_rx_bytes; dma_addr_t dma_addr; u32 genfifoentry; + bool isinstr; enum mode_type mode; }; @@ -405,9 +407,20 @@ static void zynqmp_qspi_chipselect(struct spi_device *qspi, bool is_high) genfifoentry |= GQSPI_GENFIFO_MODE_SPI; genfifoentry |= xqspi->genfifobus; + if (qspi->master->flags & SPI_MASTER_BOTH_CS) { + zynqmp_gqspi_selectslave(xqspi, + GQSPI_SELECT_FLASH_CS_BOTH, + GQSPI_SELECT_FLASH_BUS_BOTH); + } else { + zynqmp_gqspi_selectslave(xqspi, + GQSPI_SELECT_FLASH_CS_LOWER, + GQSPI_SELECT_FLASH_BUS_LOWER); + } + if (!is_high) { genfifoentry |= xqspi->genfifocs; genfifoentry |= GQSPI_GENFIFO_CS_SETUP; + xqspi->isinstr = true; } else { genfifoentry |= GQSPI_GENFIFO_CS_HOLD; } @@ -664,6 +677,7 @@ static irqreturn_t zynqmp_qspi_irq(int irq, void *dev_id) if ((xqspi->bytes_to_receive == 0) && (xqspi->bytes_to_transfer == 0) && ((status & GQSPI_IRQ_MASK) == GQSPI_IRQ_MASK)) { zynqmp_gqspi_write(xqspi, GQSPI_IDR_OFST, GQSPI_ISR_IDR_MASK); + xqspi->isinstr = false; spi_finalize_current_transfer(master); ret = IRQ_HANDLED; } @@ -827,6 +841,9 @@ static int zynqmp_qspi_start_transfer(struct spi_master *master, genfifoentry |= xqspi->genfifocs; genfifoentry |= xqspi->genfifobus; + if ((!xqspi->isinstr) && (master->flags & SPI_MASTER_DATA_STRIPE)) + genfifoentry |= GQSPI_GENFIFO_STRIPE; + zynqmp_qspi_txrxsetup(xqspi, transfer, &genfifoentry); if (xqspi->mode == GQSPI_MODE_DMA) @@ -983,6 +1000,7 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) struct zynqmp_qspi *xqspi; struct resource *res; struct device *dev = &pdev->dev; + u32 num_cs; master = spi_alloc_master(&pdev->dev, sizeof(*xqspi)); if (!master) @@ -1043,7 +1061,11 @@ static int zynqmp_qspi_probe(struct platform_device *pdev) goto clk_dis_all; } - master->num_chipselect = GQSPI_DEFAULT_NUM_CS; + ret = of_property_read_u32(pdev->dev.of_node, "num-cs", &num_cs); + if (ret < 0) + master->num_chipselect = GQSPI_DEFAULT_NUM_CS; + else + master->num_chipselect = num_cs; master->setup = zynqmp_qspi_setup; master->set_cs = zynqmp_qspi_chipselect; -- 2.1.2 -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html