Hi All, I'm trying to set up a system on an old computer. I have an Intel NUC and I put a stick of RAM into it and a new HD, and I booted to Ubuntu 18.04 that has Chirp software on it. My plan is to install that old Ubuntu with Chirp, because the new Chirp is no longer accessible, I think because of it using flatpak, so if I want to use Chirp, it's likely on an old Linux that isn't using Python 3. I put in the memory and drive, but I don't know how much RAM that particular stick is, it could be 1, 2, or 8 GB. When I start Orca, it starts and then closes out. I can open the terminal and do espeak, such as echoing its IP address with hostname -I | espeak I was hoping to SSH into it, but SSH may not be installed, but this version of Ubuntu is too old to get anything from a repository. But if I can find out the amount of RAM I installed, I might be able to determine if I need to try another stick of RAM, because I'm guessing that if it is just a 1 GB RAM, maybe that is why Orca is starting and stopping. So, my question is, Is there a command that I can pipe the output to eSpeak to hear the information on how much RAM there is? Like I did with the hostname -I command. Thanks in advance. Glenn
