Hi, This link helped me to setup successfully my Apollo II synth: https://raw.githubusercontent.com/bytefire/speakup-decext/master/decext-instructions.txt Best, Pawel On 2/17/18, Rudy Vener <salt@xxxxxxxxx> wrote: > My synthesizer says Digital DecTalk Express on its case. > It is a flat, rectangular box about eight inches by four inches by > one inch high. It has a cable with a DB-9F connector that plugs > into an external RS-232 Serial port. > It has a volume control, a built in speaker, and a headphone > jack. > > I thought this was an external Dectalk Express because it sat > outside the PC and does not plug into an expansion slot. > > I thought the speakup_dectlk module was for the Dectalk Express > cards that did plug into PC expansion slots. > > But now I am just confused. It does not take much to confuse me. > > If there is someone out there who is using a Dectalk like the > one I just described with speakup, please contact > me, and tell me how you did it. > > Thank you. > > Rudy > > On Sat, Feb 17, 2018 at 12:00:02PM -0500, speakup-request@xxxxxxxxxxxxxxxxx > wrote: >> >> Rudy, >> >> If your model is, indeed, a DecTalk Express, you need the speakup_dectlk >> module, not the speakup_decext module. The latter is for the pre-Express >> original Dectalk, which I???ve never actually seen. Hopefully this goes >> some way towards solving your problem. >> Best, >> Zack. >> >> *************************************** > > -- > Rudy Vener > Website: http://www.rudyvener.com > _______________________________________________ > Speakup mailing list > Speakup@xxxxxxxxxxxxxxxxx > http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup > _______________________________________________ Speakup mailing list Speakup@xxxxxxxxxxxxxxxxx http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
