Hi, OK, but I'm sending the output of 'lsusb -v' separately, as it made an inline reply too big for the list. Samuel Thibault writes: > Hello, > > Janina Sajka, on ven. 15 sept. 2017 08:05:43 -0400, wrote: > > I get this even after loading usbserial, and there is indeed no > > /dev/ttyUSB0. > > Ah. Could you run > > ls /dev/tty* > root@concerto 12:56:11 ~#\ls /dev/tty* /dev/tty /dev/tty12 /dev/tty17 /dev/tty21 /dev/tty26 /dev/tty30 /dev/tty35 /dev/tty4 /dev/tty44 /dev/tty49 /dev/tty53 /dev/tty58 /dev/tty62 /dev/ttyACM0 /dev/tty0 /dev/tty13 /dev/tty18 /dev/tty22 /dev/tty27 /dev/tty31 /dev/tty36 /dev/tty40 /dev/tty45 /dev/tty5 /dev/tty54 /dev/tty59 /dev/tty63 /dev/ttyS0 /dev/tty1 /dev/tty14 /dev/tty19 /dev/tty23 /dev/tty28 /dev/tty32 /dev/tty37 /dev/tty41 /dev/tty46 /dev/tty50 /dev/tty55 /dev/tty6 /dev/tty7 /dev/ttyS1 /dev/tty10 /dev/tty15 /dev/tty2 /dev/tty24 /dev/tty29 /dev/tty33 /dev/tty38 /dev/tty42 /dev/tty47 /dev/tty51 /dev/tty56 /dev/tty60 /dev/tty8 /dev/ttyS2 /dev/tty11 /dev/tty16 /dev/tty20 /dev/tty25 /dev/tty3 /dev/tty34 /dev/tty39 /dev/tty43 /dev/tty48 /dev/tty52 /dev/tty57 /dev/tty61 /dev/tty9 /dev/ttyS3 > so perhaps some yet-unknown device would show up. Also, > > lsusb -v Will send this as an attachment separately. PS: modinfo speakup_ltlk does show: parm: ser:Set the serial port for the synthesizer (0-based). (int) parm: dev:Set the device e.g. ttyUSB0, for the synthesizer. (charp) parm: start:Start the synthesizer once it is loaded. (short) -- Janina Sajka, Phone: +1.443.300.2200 sip:janina@xxxxxxxxxxxxxxxxxxxx Email: janina@xxxxxxxxxxx Linux Foundation Fellow Executive Chair, Accessibility Workgroup: http://a11y.org The World Wide Web Consortium (W3C), Web Accessibility Initiative (WAI) Chair, Accessible Platform Architectures http://www.w3.org/wai/apa _______________________________________________ Speakup mailing list Speakup@xxxxxxxxxxxxxxxxx http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
