Hi, On Tue, Jun 27, 2017 at 01:07:47AM +0200, Samuel Thibault wrote: > Gregory Nowak, on lun. 26 juin 2017 15:35:08 -0700, wrote: > > [ 381.404108] speakup_bns: module is from the staging directory, the > > quality is unknown, you have been warned. > > [ 381.405251] synth probe > > [ 381.405260] bns: device probe failed > > > > At that point, I noticed that /dev/lp0 was missing. I fixed that by > > modprobe lp, and tried speakup_bns again with the same results as > > before. > > Mmm, Okash, did you have the opportunity to test ttyio with lp? No I didn't test with lp. But from what you've mentioned below, would you say we remove lp support from the patches until parport is implemented? > Contrary to what I expected, it seems like it doesn't actually expose a > tty layer, it doesn't seem to show up in /proc/tty/drivers, and stty -a > < /dev/lp0 fails. So I'm afraid perhaps we can't actually use ttyio for > parallel port access, and thus we have to use the parport interface. > I'd say that's not a priority, though, and we should focus on making > ttyUSB0 work for now. Thanks, Okash _______________________________________________ Speakup mailing list Speakup@xxxxxxxxxxxxxxxxx http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup