Thanks, Thomas. It works now. Chuck On Mon, Jan 29, 2007 at 05:15:18PM +0100, Tomas Cerha wrote: > Chuck Hallenbeck napsal(a): > > I want to use the new en-r voice selection. Using speak from the command > > line like this, works fine: > > > > speak -v en-r "sample of speech goes here" > > > > but when I add the -v switch to the espeak-module.conf file in the > > speech-dispatcher modules directory, it is ignored. > > Hi Chuck, > > you need to tune the voice mapping in your > /etc/speech-dispatcher/modules/espeak-generic.conf. This is done by the > AddVoice directive. There is a bunch of such directives in the default > configuration file, so you may just turn the first of them from: > > AddVoice "en" "male1" "en" > > to: > > AddVoice "en" "male1" "en-r" > > See http://www.freebsoft.org/doc/speechd/speech-dispatcher_10.html#SEC27 > for more details. > > Your GenericExecuteSynth should look like: > "echo \"$DATA\" | espeak -w /tmp/espeak.wav -v $VOICE -s $RATE -a > $VOLUME -p $PITCH --stdin && aplay /tmp/espeak.wav" > > Best regards, Tomas. > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup -- The Moon is Waxing Gibbous (87% of Full) But you can get a few downloads from http://www.mhcable.com/~chuckh
