Steve Holmes wrote: > I think the situation with speechd-el is all > punctuations are sent through and the punc level is set by changing the > punct level in speech-dispatcher. Apparently, even if > speech-dispatcher's punct level is set to none and --punct is used, > espeak still speaks the characters. So I find myself with a "all or > nothing" situation:). Hello Steve, This is quite an interesting issue and I'll try to explain why you see such inconsistent behavior right now. Several facts influence this problem: * Speech Dispatcher has support for setting three punctuation levels: - NONE -- no punctuation is read - ALL -- everything is read - SOME -- only certain characters are left out * Speakup has its own punctuation handling and speechd-up just uses the level ALL when communicating with Speech Dispatcher, because speakup strips the punctuation characters from the text internaly. This is technically not an ideal solution, but it currently gives the best results for speakup users. * Speechd-el on the other hand uses Speech Dispatcher's punctuation handling. It definitely works and there are commands to deal with puncuation, just see the speechd-el documentation. * Speech Dispatcher's generic Espeak driver currently does not support setting punctuation. You can set either --punct or not, but this results in the "all or nothing" situation as you describe. You are unable to set it according to the current Speech Dispatcher's punctuation level. So now you see why punctuation doesn't work from both - speechd-el and spd-say and why it does work from speakup. If you try with Festival, for example, you should get good results from all of them. The generic Espeak driver is the key point of our problem. Since Espeak does support punctuation setting, the only problem now is to pass the current punctuation mode from Speech Dispatcher to Espeak. I'm afraid there currently is no syntax to do that within the generic driver, but I'll look at it. Best regards, Tomas.
