Is this in answer to my question about setting speakup to use ttyS1 at the command line? I'm not sure because the subject line is similar but not the same. I specifically was asking if it can be set at the command line because setting the speakup parameters in the bootloader config hangs my system. Although, maybe you're saying I cant set speakup_ser via a boot parameter, leave out speakup_synth, and then later initialize the synth at the command line. Is that what you're saying? I tried it. It didn't work. Although, maybe it is supposed to work and my computer is messed up. Joshua Lambert said the following on 7/24/2006 3:43 PM: > In your boot loader, you need to pass the location of your serial port to > speakup if you explicitly want ttyS1. > speakup_ser=ttyS1 > Would do it from the get go. > You will have to read the docs for your boot loader to figure out how to > pass parameters to the kernel command line. > hth > Josh > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup -- -- John Heim 263-4189 / jheim at math.wisc.edu / http://www.math.wisc.edu/~jheim/
