I followed everything up to: Then go into a dos window and run the update from there. What do you mean by run the update? At 07:07 PM 5/5/2005, you wrote: >Hi, > >Its best to do this in dos mode - put the file on a floppy disk - after >uncompressing it, and run the install program. Choose not to have the >autoexec.bat or config.sys updated. Then go into a dos window and run >the update from there. Read the manual/readme for instructions. > >Thanks. >Andrew. > >-----Original Message----- >From: speakup-bounces at braille.uwo.ca >[mailto:speakup-bounces at braille.uwo.ca] On Behalf Of ace >Sent: 06 May 2005 00:04 >To: speakup at braille.uwo.ca >Subject: DECTalk Express Firmware > >Hi all, > >I downloaded the file ex-us.exe (DECTalk Express 4.61) from the GWMicro >web site. I do not understand how to install it. Am I correct that it >is firmware and installs onto the actual DECTalk unit? If this is the >case, how does one install it to the unit? I unzipped the package and >see stuff about installing onto the computer but not to the unit. > >Thanks > >Network Administrator of >irc.talkingirc.com >http://www.talkingirc.com > > >_______________________________________________ >Speakup mailing list >Speakup at braille.uwo.ca >http://speech.braille.uwo.ca/mailman/listinfo/speakup > >_______________________________________________ >Speakup mailing list >Speakup at braille.uwo.ca >http://speech.braille.uwo.ca/mailman/listinfo/speakup Network Administrator of irc.talkingirc.com http://www.talkingirc.com
