Ok thanks for the tip. I suspected this was the case...Also, further inspection of syslog revealed that the reason my test message didn't deliver propperly was bc 1. The wrong authentication module was being used. 2. The user was unknown to Courier. I'll try the copying modules thing and see what happens. On Sun, Feb 08, 2004 at 09:52:17AM -0600, Gregory Nowak wrote: > I don't run the whole courier system here, just courier-imap, and > sqwebmail. However, I think I can answer your questions given what I > know about my courier-imap and sqwebmail setup. > > Authcustom, according to the docs, is an interface between courier and > a custom authentication program that you've written for yourself. > > I know what the docs say about configure doing it all for you, but > I've found that I needed to copy the modules I needed into place by > hand after compiling and installing. My courier-imap source is > unpacked in /usr/src, so my module binaries after compilation are > found in > /usr/src/courier-imap-2.2.1/authlib/ > . You'll find the binaries for authshadow and friends in whatever your > equivalent source directory is, just copy them over to where they need > to be, and add them to authdaemonrc. My authdaemonrc modules section > looks like this: > > > ##NAME: authmodulelist:0 > # > # The authentication modules that are linked into authdaemond. The > # default list is installed. You may selectively disable modules > #simply > # by removing them from the following list. The available modules you > # can use are: authcustom authcram authuserdb authmysql authshadow > #authpwd > > authmodulelist="authshadow authuserdb" > > > > Hth. > > Greg > > P.S. Remember to restart courier when you're done making changes. > > On Sun, Feb 08, 2004 at 02:41:58AM -0500, Igor Gueths wrote: > > Hi all. I'm attempting to set up Courier here, except I've run into a > > problem related to the various authentication modules. In > > /usr/lib/courier/etc/authdaemonrc, the only modules that are in the list > > are authcustom, authcram, and authldap. What exactly is authcustom? > > Also, the install file says that configure is supposed to install the > > correct modules for your system...Where is authpw and authshadow, and > > authpam? Bc theoretically, these modules should have been installed. I > > am using shadow passwords, and I know I can use pam because I have > > configuration files for it in /etc/pam.d. Is this a case of configure > > not guessing correct values, and I have to explicitly specify the > > modules I want to use? I currently have Courier-0.44.2. Anyone know why > > I am getting this strange behavior? P.S: Just for testing purposes, I > > started courier and echoed a message to postmaster, who I aliased to my > > main user account (igueths). I created a Maildir, and then sent the > > test...Sure enough, no message present when I tried to read it with > > Mutt. However, all the syslog messages indicate that Courier > > successfully sent the message...No errors. > > > > _______________________________________________ > > Speakup mailing list > > Speakup at braille.uwo.ca > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > -- > Free domains: http://www.eu.org/ or mail dns-manager at EU.org > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup
