Some device might indeed be using the settings for com1 but that might be resolved by deleting com2 and restarting. Then if there is no ports in device manager, then he could add a port and assign the typical address for com1 In fact he should go into the properties and attempt to manipulate the settings to the com2 to match the typical com 2 settings if they aren't already. Com1 & 3 use IRQ 4 and Com2 & 4 use IRQ 3. Then there is the memory range, which I always have to check before setting, but com1 usually uses 03f8 I think and com2 uses 02f8, or something like that. But in windows we sometimes have to shuffle this stuff around and sometimes we have to delete the item and a few others so we can re-assign the problem devices. ----- Original Message ----- From: "Janina Sajka" <janina@xxxxxxxxxxx> To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca> Sent: Friday, February 06, 2004 8:24 AM Subject: Re: can't find serial port This suggests to me that some other device is being assigned com1. Recognize that the designation com1 is logical, not physical. Kyrath. (AKA Rob) writes: > From: "Kyrath. \(AKA Rob\)" <kyrath at cox.net> > > Alright, I tried the mode command and it seems to work in that it made the > adjustment. When I tried the mode command for com2 or com3, it gave me an > illegal device error. > The strange thing is that I looked in the windoes device manager and found > that there was no com1 listed, but there was a com2. Go figure. > I guess that I'll have to wait for some eyes before I can do any more. > Thanks for all of the help. > -- Rob > ----- Original Message ----- > From: "Glenn Ervin at Home" <GlennErvin at cableone.net> > To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca> > Sent: Thursday, February 05, 2004 9:54 PM > Subject: Re: can't find serial port > > > > You might also try the following in a DOS box or at the DOS prompt: > > mode com1 9600,n,8,1,, > > That is the typical port settings. > > ----- Original Message ----- > > From: "Kyrath. (AKA Rob)" <kyrath at cox.net> > > To: "Speakup is a screen review system for Linux." > <speakup at braille.uwo.ca> > > Sent: Thursday, February 05, 2004 7:20 PM > > Subject: Re: can't find serial port > > > > > > OK, it looks like the port might be disabled. The copy command came back > > with 1 file copied, but there was no output. > > is it possible that the port is ph > > > > _______________________________________________ > > Speakup mailing list > > Speakup at braille.uwo.ca > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup -- Janina Sajka Email: janina at rednote.net Phone: +1 (202) 408-8175 Director, Technology Research and Development American Foundation for the Blind (AFB) http://www.afb.org Chair, Accessibility Work Group Free Standards Group http://a11y.org _______________________________________________ Speakup mailing list Speakup at braille.uwo.ca http://speech.braille.uwo.ca/mailman/listinfo/speakup
