Hi there. Does it obtain any information from the DHCP server such as gateway, subnet mask, or anything like that? ----- Original Message ----- From: "Alex Snow" <alex_snow@xxxxxxx> To: <speakup at braille.uwo.ca> Sent: Saturday, October 05, 2002 4:38 PM Subject: Network card problems > Hi all, > > i put a 3com etherlink3 isa ethernet card into my linux box. When I ran > netconfig to set up the network, I filled out all my settings, like using > dhcp and the address of my dhcp server, and when it asked if I wanted it to > probe for my nic, I said yes. It came back with the right network card, > using the 3c509 module. I then finished netconfig, and ran ifconfig eth0. > And now my problem occurred. Everything was shown, like mac address, etc, > but no ip address. Also the link light on my router wasn't on for that > port. I restarted and found that the link light on the router turns on for > about 5 seconds during boot, then goes out. > What could be my problem? > Explorer has caused a general protection fault in module kernel32.dll. I'm > sick of Winblows! > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup >
