If you created a boot disk during setup, then use that to get yourself into your system. If not, then you can still grab a speakup enabled disk off the speakup sight, and boot with that plus a root disk. If your lilo.conf is all that you modified, then your new 2.4.6 with speakup is still wherever you left it last for booting with. Greg On Mon, Sep 24, 2001 at 02:45:53PM +0100, Tim Burgess wrote: > Hi all, > > I got a good kernel compile out of 2.4.6 and SpeakUp 0.10a.tar.gz then blew > it all by getting my lilo.conf entry wrong, I think. I'm now stuck until I > can borrow some eyeballs to see if I can retrieve the situation. > > In the meantime, thanks to all of you who have gritted your teeth at my > incompetence so far. > > Tim > > > -----Original Message----- > From: speakup-admin at braille.uwo.ca > [mailto:speakup-admin at braille.uwo.ca]On Behalf Of William F. Acker > WB2FLW +1-303-777-8123 > Sent: 23 September 2001 21:18 > To: speakup at braille.uwo.ca > Subject: RE: kernel compile gone wrong. > > > Hi, Tim, > > I have a patch for 2.4 kernels made from the 20010917 CVS snapshot of > Speakup. I can make a 2.2 version if you need it. Just say the word and > I'll send it off. > > > > > HTH. > Bill in Denver > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup
