The kernel is a bzImage of 651,696 bytes. Is that too large? Seems to me that this should just make it. The exact error lilo is reporting is: geo_comp_addr: Cylinder number is too big (1530 > 1023) Sure sounds like the old "keep it below 1024" There was one other problem, now that I look back at the logs. 'make modules_install' complained about depmod -f. I ran depmod -a 2.4.0 by hand, but is this perhaps not the same thing? Might this be a modules issue? On 8 Jan 2001, Kirk Reiser wrote: > Hi Again Janina: Check the size of the kernel you built. Did you > compile it as a zImage or a bzImage? Looks more like lilo is > complaning about the size of the kernel rather than the size of the > drive. > > Kirk > > -- > > Kirk Reiser The Computer Braille Facility > e-mail: kirk at braille.uwo.ca University of Western Ontario > phone: (519) 661-3061 > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup >
