From: Sunil Goutham <sgoutham@xxxxxxxxxxx>
Resource virtualization unit (RVU) on Marvell's OcteonTX2 SOC supports
multiple PCIe SRIOV physical functions (PFs) and virtual functions (VFs).
PF0 is called administrative / admin function (AF) and has privilege access
to registers to provision different RVU functional blocks to each of
PF/VF.
This admin function (AF) driver acts as a configuration / administrative
software which provisions functional blocks to a PF/VF on demand for them
to work as one of the following
- A basic network controller (i.e NIC).
- NIC with packet filtering, shaping and scheduling capabilities.
- A crypto device.
- A combination of above etc.
PF/VFs communicate with admin function via a shared memory region.
This patch series adds logic for the following
- RVU AF driver with functional blocks provisioning support
- Mailbox infrastructure for communication between AF and PFs.
- CGX driver which provides information about physcial network
interfaces which AF processes and forwards required info to
PF/VF drivers.
This is the first set of patches out of 70 odd patches.
Note: This driver neither receives any data nor processes it i.e no I/O,
just does the hardware configuration.
Changes from v2:
No changes, submitted again with netdev mailing list in loop.
- Suggested by Arnd Bergmann and Andrew Lunn
Changes from v1:
1 Merged RVU admin function and CGX drivers into a single module
- Suggested by Arnd Bergmann
2 Pulled mbox communication APIs into a separate module to remove
admin function driver dependency in a VM where AF is not attached.
- Suggested by Arnd Bergmann
Aleksey Makarov (2):
soc: octeontx2: Add mailbox support infra
soc: octeontx2: Convert mbox msg id check to a macro
Geetha sowjanya (1):
soc: octeontx2: Reconfig MSIX base with IOVA
Linu Cherian (3):
soc: octeontx2: Set RVU PFs to CGX LMACs mapping
soc: octeontx2: Add support for CGX link management
soc: octeontx2: Register for CGX lmac events
Sunil Goutham (9):
soc: octeontx2: Add Marvell OcteonTX2 RVU AF driver
soc: octeontx2: Reset all RVU blocks
soc: octeontx2: Gather RVU blocks HW info
soc: octeontx2: Add mailbox IRQ and msg handlers
soc: octeontx2: Scan blocks for LFs provisioned to PF/VF
soc: octeontx2: Add RVU block LF provisioning support
soc: octeontx2: Configure block LF's MSIX vector offset
soc: octeontx2: Add Marvell OcteonTX2 CGX driver
MAINTAINERS: Add entry for Marvell OcteonTX2 Admin Function driver
MAINTAINERS | 10 +
drivers/soc/Kconfig | 1 +
drivers/soc/Makefile | 1 +
drivers/soc/marvell/Kconfig | 18 +
drivers/soc/marvell/Makefile | 2 +
drivers/soc/marvell/octeontx2/Makefile | 10 +
drivers/soc/marvell/octeontx2/cgx.c | 517 +++++++++
drivers/soc/marvell/octeontx2/cgx.h | 65 ++
drivers/soc/marvell/octeontx2/cgx_fw_if.h | 225 ++++
drivers/soc/marvell/octeontx2/mbox.c | 303 +++++
drivers/soc/marvell/octeontx2/mbox.h | 211 ++++
drivers/soc/marvell/octeontx2/rvu.c | 1637 ++++++++++++++++++++++++++++
drivers/soc/marvell/octeontx2/rvu.h | 158 +++
drivers/soc/marvell/octeontx2/rvu_cgx.c | 194 ++++
drivers/soc/marvell/octeontx2/rvu_reg.h | 442 ++++++++
drivers/soc/marvell/octeontx2/rvu_struct.h | 78 ++
16 files changed, 3872 insertions(+)
create mode 100644 drivers/soc/marvell/Kconfig
create mode 100644 drivers/soc/marvell/Makefile
create mode 100644 drivers/soc/marvell/octeontx2/Makefile
create mode 100644 drivers/soc/marvell/octeontx2/cgx.c
create mode 100644 drivers/soc/marvell/octeontx2/cgx.h
create mode 100644 drivers/soc/marvell/octeontx2/cgx_fw_if.h
create mode 100644 drivers/soc/marvell/octeontx2/mbox.c
create mode 100644 drivers/soc/marvell/octeontx2/mbox.h
create mode 100644 drivers/soc/marvell/octeontx2/rvu.c
create mode 100644 drivers/soc/marvell/octeontx2/rvu.h
create mode 100644 drivers/soc/marvell/octeontx2/rvu_cgx.c
create mode 100644 drivers/soc/marvell/octeontx2/rvu_reg.h
create mode 100644 drivers/soc/marvell/octeontx2/rvu_struct.h
--
2.7.4
