Hi Abhishek,
On 2/3/2018 4:47 PM, Abhishek Sahu wrote:
> On 2018-01-29 10:41, Sricharan R wrote:
>> Add the common parts for the dk04 boards.
>>
>> Signed-off-by: Sricharan R <sricharan@xxxxxxxxxxxxxx>
>> ---
>> arch/arm/boot/dts/qcom-ipq4019-ap.dk04.1.dtsi | 147
>
> <snip>
>> +
>> + nand_pins: nand_pins {
>> + pullups {
>> + pins = "gpio52", "gpio53",
>> "gpio58",
>> + "gpio59";
>> + function = "qpic";
>> + bias-pull-up;
>> + };
>> +
>> + pulldowns {
>> + pins = "gpio54", "gpio55",
>> "gpio56",
>> + "gpio57", "gpio60",
>> "gpio61",
>> + "gpio62", "gpio63",
>> "gpio64",
>> + "gpio65", "gpio66",
>> "gpio67",
>> + "gpio68", "gpio69";
>> + function = "qpic";
>> + bias-pull-down;
>> + };
>> + };
>
> Can you please check once why do we need pull-up and
> pull-down for NAND pins. The NAND chip will be mounted
> over board itself so board design should take care of
> required pull up and pull downs.
>
Mostly because, these are always **weak** pull up/down as defaults
and should be overridden by the ones in the board (if there).
> Also, some of the above pins like gpio52 will be only used
> for LCD so we can remove those pins. Later on, when LCD
> support will be added, we can add those pins.
ok
Regards,
Sricharan
--
"QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
--
To unsubscribe from this list: send the line "unsubscribe linux-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
