These nodes reserve and configure some pins as GPIOs. They are not
generic pinctrls, they actually belong to board files but they are not
used by any other node, so just drop them altogether.
Signed-off-by: Damien Riegel <damien.riegel@xxxxxxxxxxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 52 ------------------------------
1 file changed, 52 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
index 10fc1fc90682..21f144c55638 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
@@ -505,32 +505,6 @@
};
};
- ext-codec-lines {
- ext_codec_lines_act: lines_on {
- pinmux {
- function = "gpio";
- pins = "gpio67";
- };
- pinconf {
- pins = "gpio67";
- drive-strength = <8>;
- bias-disable;
- output-high;
- };
- };
- ext_codec_lines_sus: lines_off {
- pinmux {
- function = "gpio";
- pins = "gpio67";
- };
- pinconf {
- pins = "gpio67";
- drive-strength = <2>;
- bias-disable;
- };
- };
- };
-
cdc-pdm-lines {
cdc_pdm_lines_act: pdm_lines_on {
pinmux {
@@ -703,32 +677,6 @@
};
};
- cross-conn-det {
- cross_conn_det_act: lines_on {
- pinmux {
- function = "gpio";
- pins = "gpio120";
- };
- pinconf {
- pins = "gpio120";
- drive-strength = <8>;
- output-low;
- bias-pull-down;
- };
- };
- cross_conn_det_sus: lines_off {
- pinmux {
- function = "gpio";
- pins = "gpio120";
- };
- pinconf {
- pins = "gpio120";
- drive-strength = <2>;
- bias-disable;
- };
- };
- };
-
wcnss_pin_a: wcnss-active {
pinmux {
pins = "gpio40", "gpio41", "gpio42", "gpio43", "gpio44";
--
2.15.0
--
To unsubscribe from this list: send the line "unsubscribe linux-soc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
