SGI IOC3 ASIC includes support for ethernet, PS2 keyboard/mouse, NIC (number in a can), GPIO and a byte bus. By attaching a SuperIO chip to it, it also supports serial lines and a parallel port. The chip is used on a variety of SGI systems with different configurations. This patchset moves code out of the network driver, which doesn't belong there, into its new place a MFD driver and specific platform drivers for the different subfunctions. Changes in v3: - use 1-wire subsystem for handling proms - pci-xtalk driver uses prom information to create PCI subsystem ids for use in MFD driver - changed MFD driver to only use static declared mfd_cells - added IP30 system board setup to MFD driver - mac address is now read from ioc3-eth driver with nvmem framework Changes in v2: - fixed issue in ioc3kbd.c reported by Dmitry Torokhov - merged IP27 RTC removal and 8250 serial driver addition into main MFD patch to keep patches bisectable Thomas Bogendoerfer (7): nvmem: core: add nvmem_device_find MIPS: PCI: refactor ioc3 special handling MIPS: PCI: use information from 1-wire PROM for IOC3 detection MIPS: SGI-IP27: remove ioc3 ethernet init mfd: ioc3: Add driver for SGI IOC3 chip MIPS: SGI-IP27: fix readb/writeb addressing Input: add IOC3 serio driver arch/mips/include/asm/mach-ip27/mangle-port.h | 4 +- arch/mips/include/asm/pci/bridge.h | 1 + arch/mips/include/asm/sn/ioc3.h | 356 ++--- arch/mips/pci/pci-xtalk-bridge.c | 296 ++-- arch/mips/sgi-ip27/ip27-console.c | 5 +- arch/mips/sgi-ip27/ip27-init.c | 13 - arch/mips/sgi-ip27/ip27-timer.c | 20 - arch/mips/sgi-ip27/ip27-xtalk.c | 38 +- drivers/input/serio/Kconfig | 10 + drivers/input/serio/Makefile | 1 + drivers/input/serio/ioc3kbd.c | 158 ++ drivers/mfd/Kconfig | 13 + drivers/mfd/Makefile | 1 + drivers/mfd/ioc3.c | 683 +++++++++ drivers/net/ethernet/sgi/Kconfig | 4 +- drivers/net/ethernet/sgi/ioc3-eth.c | 1932 ++++++++++--------------- drivers/nvmem/core.c | 62 +- drivers/rtc/rtc-m48t35.c | 11 + drivers/tty/serial/8250/8250_ioc3.c | 98 ++ drivers/tty/serial/8250/Kconfig | 11 + drivers/tty/serial/8250/Makefile | 1 + include/linux/nvmem-consumer.h | 9 + 22 files changed, 2152 insertions(+), 1575 deletions(-) create mode 100644 drivers/input/serio/ioc3kbd.c create mode 100644 drivers/mfd/ioc3.c create mode 100644 drivers/tty/serial/8250/8250_ioc3.c -- 2.13.7
