The Meegopad T08 hdmi-stick (think Intel computestick) has a brcm43430 wifi/bt combo chip. The BCM2E90 ACPI device describing the BT part does contain a valid ActiveLow GpioInt entry, but the GPIO it points to never goes low, so either the IRQ pin is not connected, or the ACPI resource- table points to the wrong GPIO. Eitherway things will not work if we try to use the specified IRQ, this commits adds a DMI based broken-irq blacklist and disables use of the IRQ and thus also runtime-pm for devices on this list. This blacklist starts with the the Meegopad T08, fixing bluetooth not working on this hdmi-stick. Since this is not a battery powered device the loss of runtime-pm is not really an issue. Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/bluetooth/hci_bcm.c | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c index 06e2434c9b3d..fba43902af83 100644 --- a/drivers/bluetooth/hci_bcm.c +++ b/drivers/bluetooth/hci_bcm.c @@ -794,6 +794,20 @@ static const struct acpi_gpio_mapping acpi_bcm_int_first_gpios[] = { { }, }; +/* Some firmware reports an IRQ which does not work (wrong pin in fw table?) */ +static const struct dmi_system_id bcm_broken_irq_dmi_table[] = { + { + .ident = "Meegopad T08", + .matches = { + DMI_EXACT_MATCH(DMI_BOARD_VENDOR, + "To be filled by OEM."), + DMI_EXACT_MATCH(DMI_BOARD_NAME, "T3 MRD"), + DMI_EXACT_MATCH(DMI_BOARD_VERSION, "V1.1"), + }, + }, + { } +}; + #ifdef CONFIG_ACPI /* IRQ polarity of some chipsets are not defined correctly in ACPI table. */ static const struct dmi_system_id bcm_active_low_irq_dmi_table[] = { @@ -911,6 +925,8 @@ static int bcm_gpio_set_shutdown(struct bcm_device *dev, bool powered) static int bcm_get_resources(struct bcm_device *dev) { + const struct dmi_system_id *dmi_id; + dev->name = dev_name(dev->dev); if (x86_apple_machine && !bcm_apple_get_resources(dev)) @@ -943,6 +959,13 @@ static int bcm_get_resources(struct bcm_device *dev) dev->irq = gpiod_to_irq(gpio); } + dmi_id = dmi_first_match(bcm_broken_irq_dmi_table); + if (dmi_id) { + dev_info(dev->dev, "%s: Has a broken IRQ config, disabling IRQ support / runtime-pm\n", + dmi_id->ident); + dev->irq = 0; + } + dev_dbg(dev->dev, "BCM irq: %d\n", dev->irq); return 0; } -- 2.14.3 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html