The rs485 flag "SER_RS485_RTS_AFTER_SEND" was wrongly read from the GPIO
flags. This caused the RTS to be high during boot.
Signed-off-by: Rafael Gago Castano <rgc@xxxxxx>
---
drivers/tty/serial/omap-serial.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 53d59e9..cc9826e 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1602,7 +1602,6 @@ static int serial_omap_probe_rs485(struct uart_omap_port *up,
struct device_node *np)
{
struct serial_rs485 *rs485conf = &up->port.rs485;
- enum of_gpio_flags flags;
int ret;
rs485conf->flags = 0;
@@ -1617,13 +1616,13 @@ static int serial_omap_probe_rs485(struct uart_omap_port *up,
rs485conf->flags |= SER_RS485_RTS_AFTER_SEND;
/* check for tx enable gpio */
- up->rts_gpio = of_get_named_gpio_flags(np, "rts-gpio", 0, &flags);
+ up->rts_gpio = of_get_named_gpio(np, "rts-gpio", 0);
if (gpio_is_valid(up->rts_gpio)) {
ret = devm_gpio_request(up->dev, up->rts_gpio, "omap-serial");
if (ret < 0)
return ret;
- ret = gpio_direction_output(up->rts_gpio,
- flags & SER_RS485_RTS_AFTER_SEND);
+ ret = rs485conf->flags & SER_RS485_RTS_AFTER_SEND ? 1 : 0;
+ ret = gpio_direction_output(up->rts_gpio, ret);
if (ret < 0)
return ret;
} else if (up->rts_gpio == -EPROBE_DEFER) {
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
