Hi Baruch,
On 20.02.2017 20:20, Baruch Siach wrote:
Hi Piotr,
On Mon, Feb 20, 2017 at 02:54:02PM +0100, Piotr Figiel wrote:
I'm looking to find a correct way to disable RX in the I.MX6 UART during
TX-ing. I stumbled on the issue described below when working on
~SER_RS485_RX_DURING_TX on custom 3.10 tree (branched from Freescale's/NXP's
BSP release) independently to what is now in the main line imx.c, but I see
now that the implementation in mainline also seem to have the same problem
I'm trying to solve now. I would like to request for comments to
confirm/deny whether the issue I raise here is valid and how to best
approach this.
I'm mostly concerned about the fact that the URXD register must not be
accessed (as documented in IMX.6 RM) when RX is disabled (RXEN=0). The issue
is that in the following sequence happening during imx_start_tx with
~SER_RS485_RX_DURING_TX set:
1. Acquire spinlock, disable local interrupts (from serial_core.c),
2. Disable RX receiver (RXEN=0 in UCR2),
3. Release spinlock, reenable interrupts.
The RX fifo may become not empty between #1 and #2. This will raise
interrupt which will be handled after re-enabling interrupts (after #3). ISR
in this case will check the status bit of the interrupt and fetch RX FIFO
contents, which I understand is forbidden by the documentation and may raise
error on the bus [1]. In addition disabling RX IRQ in this procedure, e.g.
after #1 doesn't seem to be enough, as the IRQ still may trigger after #1
and will need to be serviced.
As I understand it, SER_RS485_RX_DURING_TX is for half-duplex RS-485 where
only one device is allowed to transmit at any given time. Higher level code
determines when any given device on the bus is allowed to transmit. If Rx FIFO
becomes non-empty during Tx enable, you have a contention problem to solve.
That's correct, although I don't want bugs from the user-space or
misbehaving devices on RS-485 to cause errors on the AXI/AHB bus
resulting with possible crash/exception on the CPU core. The reason I
write about this is that the RM explicitly forbids accessing those
registers in such case.
What is your use case?
My use-case is as you wrote - RS-485 in half duplex. I need to disable
acquisition of data on RX on UART ip core level when TXing. Upper layer
protocol in normal conditions does not let the issue I mentioned here
happen.
Best regards, Piotr.
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
