Having just defined some new Pinctrl groups for when HW flow-control is {en,dis}abled, let's reference them for use within the driver. Acked-by: Peter Griffin <peter.griffin@xxxxxxxxxx> Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx> --- arch/arm/boot/dts/stih407-family.dtsi | 3 +-- arch/arm/boot/dts/stih410-b2260.dts | 5 ++++- 2 files changed, 5 insertions(+), 3 deletions(-) diff --git a/arch/arm/boot/dts/stih407-family.dtsi b/arch/arm/boot/dts/stih407-family.dtsi index c8b2944..e480e32 100644 --- a/arch/arm/boot/dts/stih407-family.dtsi +++ b/arch/arm/boot/dts/stih407-family.dtsi @@ -222,9 +222,8 @@ compatible = "st,asc"; reg = <0x9830000 0x2c>; interrupts = <GIC_SPI 122 IRQ_TYPE_NONE>; - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_serial0>; clocks = <&clk_s_c0_flexgen CLK_EXT2F_A9>; + /* Pinctrl moved out to a per-board configuration */ status = "disabled"; }; diff --git a/arch/arm/boot/dts/stih410-b2260.dts b/arch/arm/boot/dts/stih410-b2260.dts index fa16aba..cbcbcb4 100644 --- a/arch/arm/boot/dts/stih410-b2260.dts +++ b/arch/arm/boot/dts/stih410-b2260.dts @@ -62,8 +62,11 @@ /* Low speed expansion connector */ uart0: serial@9830000 { label = "LS-UART0"; - status = "okay"; + pinctrl-names = "default", "no-hw-flowctrl"; + pinctrl-0 = <&pinctrl_serial0_hw_flowctrl>; + pinctrl-1 = <&pinctrl_serial0>; rts-gpios = <&pio17 3 GPIO_ACTIVE_LOW>; + status = "okay"; }; /* Low speed expansion connector */ -- 2.9.3 -- To unsubscribe from this list: send the line "unsubscribe linux-serial" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html