On Thu, Oct 20, 2016 at 05:15:40PM +0800, zhichang.yuan wrote:
> On Hip06, the accesses to LPC peripherals work in an indirect way. A
> corresponding LPC driver configure some registers in LPC master at first, then
> the real accesses on LPC slave devices are finished by the LPC master, which
> is transparent to LPC driver.
> This patch implement the relevant driver for Hip06 LPC. Cooperating with
> indirect-IO, ipmi messages is in service without any changes on ipmi driver.
>
> Signed-off-by: zhichang.yuan <yuanzhichang@xxxxxxxxxxxxx>
> Signed-off-by: Gabriele Paoloni <gabriele.paoloni@xxxxxxxxxx>
> ---
> .../arm/hisilicon/hisilicon-low-pin-count.txt | 31 ++
> MAINTAINERS | 8 +
> drivers/bus/Kconfig | 8 +
> drivers/bus/Makefile | 1 +
> drivers/bus/hisi_lpc.c | 501 +++++++++++++++++++++
> 5 files changed, 549 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/arm/hisilicon/hisilicon-low-pin-count.txt
> create mode 100644 drivers/bus/hisi_lpc.c
>
> diff --git a/Documentation/devicetree/bindings/arm/hisilicon/hisilicon-low-pin-count.txt b/Documentation/devicetree/bindings/arm/hisilicon/hisilicon-low-pin-count.txt
> new file mode 100644
> index 0000000..e681419
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/arm/hisilicon/hisilicon-low-pin-count.txt
> @@ -0,0 +1,31 @@
> +Hisilicon Hip06 low-pin-count device
> + Usually LPC controller is part of PCI host bridge, so the legacy ISA ports
> + locate on LPC bus can be accessed direclty. But some SoCs have independent
> + LPC controller, and access the legacy ports by triggering LPC I/O cycles.
> + Hisilicon Hip06 implements this LPC device.
> +
> +Required properties:
> +- compatible: should be "hisilicon,low-pin-count"
This should be an SoC specific compatible string.
> +- #address-cells: must be 2 which stick to the ISA/EISA binding doc.
> +- #size-cells: must be 1 which stick to the ISA/EISA binding doc.
> +- reg: base memory range where the register set for this device is mapped.
> +
> +Note:
> + The node name before '@' must be "isa" to represent the binding stick to the
> + ISA/EISA binding specification.
> +
> +Example:
> +
> +isa@a01b0000 {
> + compatible = "hisilicom,low-pin-count";
> + #address-cells = <2>;
> + #size-cells = <1>;
> + reg = <0x0 0xa01b0000 0x0 0x1000>;
> +
> + ipmi0: bt@e4 {
> + compatible = "ipmi-bt";
> + device_type = "ipmi";
> + reg = <0x01 0xe4 0x04>;
> + status = "disabled";
> + };
> +};
--
To unsubscribe from this list: send the line "unsubscribe linux-serial" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
